图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
国际能源材料和化学驱动期刊
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN 打印: 2150-766X
ISSN 在线: 2150-7678

国际能源材料和化学驱动期刊

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v2.i1-6.210
pages 361-374

BORON PROPELLANTS FOR DUCTED ROCKET APPLICATION

B. Mahe
Groupe Recherche Propulsion, SNPE-CRB, France
Christian Perut
Groupe Recherche Propulsion, SNPE Matériaux Energétiques CRB, France

ABSTRACT

A research program was conducted to optimize the processability and evaluate the properties of fuel-rich solid propellants heavily loaded with boron. Propellants containing large amounts of boron pose specific problems. Good manufacturing and mechanical properties require definition of the specifications for the raw material, and development of a method for the mixing operation. The maximum stress is usually between 1.4 and 2.5 MPa, and the strain at maximum stress between 35 and 50 %.
The computed volumetric specific impulses are between 1600 and 1800 s g cm−3 for a flight at Mach 2 and sea level, with a chamber pressure equal to 0.57 MPa and an equivalence ratio of 0.4. Ballistic evaluations were performed by firing end-burning grains. A large burning rate range is achieved by varying the ammonium perchlorate particle size and the ballistic catalyst content. This allows operation in the choked gas generator or in the unchoked gas generator configuration. The burning rate required at the operating pressure is between 8 and 15 mm/s for an end-burning grain. The unchoked gas generator configuration demands high burning rate propellant because of the low operating pressure. These compositions produce no combustion residue, but leave slag in the gas generator, with a mass corresponding to less than 1 % of the initial mass of the grain.


Articles with similar content:

HIGH BURNING RATE SOLID ROCKET PROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.4, 1997, issue 1-6
G. Doriath
ENVIRONMENT-FRIENDLY COMPOSITE PROPELLANTS BASED ON AMMONIUM DINITRAMIDE
International Journal of Energetic Materials and Chemical Propulsion, Vol.18, 2019, issue 1
Claudio Tagliabue, Volker Weiser, Volker Gettwert, Sven Hafner, Sebastian Fischer
COMBUSTION CHARACTERISTICS OF KEROSENE CONTAINING ALEX® NANO-ALUMINUM
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
Frederick Tepper, L. A. Kaledin
BALLISTIC AND COMBUSTION PROPERTIES OF HIGH-PRESSURE EXPONENT HYDROCARBON-BASED FUEL-RICH PROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
Gideon J. van Zyl
INVESTIGATION OF SOLID OXIDIZER AND GASEOUS FUEL COMBUSTION PERFORMANCE USING AN ELEVATED PRESSURE COUNTERFLOW EXPERIMENT FOR REVERSE HYBRID ROCKET ENGINE
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 6
Grant A. Risha, Terrence L. Connell, Jr., Reed H. Johansson, Gregory Young, Richard A. Yetter