图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
传热学
影响因子: 0.404 5年影响因子: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN 打印: 1064-2285
ISSN 在线: 2162-6561

传热学

DOI: 10.1615/HeatTransRes.2018016441
pages 1199-1218

BUBBLE BEHAVIOR AND BUBBLE GROWTH MODEL OF HIGHLY SUBCOOLED FLOW BOILING IN A VERTICAL RECTANGULAR CHANNEL

Dewen Yuan
CNNC Key Laboratory on Nuclear Reactor Thermal Hydraulics Technology, Nuclear Power Institute of China, Chengdu 610041, PR China
Xiao Yan
CNNC Key Laboratory on Nuclear Reactor Thermal Hydraulics Technology, Nuclear Power Institute of China, Chengdu 610041, PR China; Institute of Nuclear and New Energy Technology, Collaborative Innovation Center of Advanced Nuclear Energy Technology, Key Laboratory of Advanced Reactor Engineering and Safety of Ministry of Education, Tsinghua University, Beijing 100084, China; Department of Mechanical Science and Engineering, University of Illinois at Urbana–Champaign, Urbana, IL, 61801, USA
Deqi Chen
Key Laboratory of Low-Grade Energy Utilization Technologies and Systems (Chongqing University), Ministry of Education, Chongqing 40044, PR China
Yunke Zhong
Key Laboratory of Low-Grade Energy Utilization Technologies and Systems (Chongqing University), Ministry of Education, Chongqing 40044, PR China
Yanping Huang
CNNC Key Laboratory on Nuclear Reactor Thermal Hydraulics Technology, Nuclear Power Institute of China, Chengdu 610041, PR China
Jianjun Xu
CNNC Key Laboratory on Nuclear Reactor Thermal Hydraulics Technology, Nuclear Power Institute of China, Chengdu 610041, PR China

ABSTRACT

In the paper, a visual investigation was carried out to study the bubble behavior phenomena with upward subcooled flow boiling in a narrow channel, with a gap of 2 mm. It was found that the bubbles grew up rapidly at different nucleation sites and then condensed subsequently with high bulk subcooling, under system pressures of 0.1 MPa and 0.3 MPa. Under a system pressure of 0.6 MPa and 1.0 MPa, bubbles were generated continuously at different nucleation sites and slid along the heating surface during the growing process. Based on the experimental study, a bubble growth model was proposed with consideration of the bubble behavior and the local thermal condition near the heating wall; the parameters of the proposed model considered the effect of wall superheating and the degree of bulk subcooling, and the Reynolds number Re considered the bulk velocity; these considerations were used to modify the Zuber model. Then the proposed bubble growth model was used to predict the bubble growing process.


Articles with similar content:

TEMPERATURE FLUCTUATION CHARACTERISTICS OF POOL BOILING WITHIN SPACE-CONFINED STRUCTURES
Heat Transfer Research, Vol.47, 2016, issue 3
Zhaolong Hao, Wei Xu, Zhong Lan, Chunjian Yu, Xuehu Ma
INVESTIGATION OF SUBCOOLED FLOW BOILING HEAT TRANSFER AT 1 ~ 3 BAR
First Thermal and Fluids Engineering Summer Conference, Vol.15, 2015, issue
Pervej Rahman, Masahiro Kawaji, Randy Samaroo
BUBBLE LIFT-OFF IN FORCED CONVECTIVE SUBCOOLED BOILING FLOW
International Heat Transfer Conference 13, Vol.0, 2006, issue
Goon Cherl Park, T. Hibiki, Guan Heng Yeoh, Michitsugu Mori, Mamoru Ishii, Jiyuan Tu, R. Situ
FLOW BOILING OF WATER IN A HYDROPHOBIC COATED SMALL DIAMETER TUBE
First Thermal and Fluids Engineering Summer Conference, Vol.15, 2015, issue
Arcot R Balakrishnan, Manoharan Aravinthan, Sarit Kumar Das, Sourav Sarkar
WALL EFFECTS ON SUBCOOLED BOILING-INDUCED VIBRATION PHENOMENA OF A SINGLE HEATER ROD
First Thermal and Fluids Engineering Summer Conference, Vol.15, 2015, issue
Yusuke Hashimoto, Tomoaki Kunugi, Kenji Takano, Zensaku Kawara, Takehiko Yokomine