图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
传热学
影响因子: 0.404 5年影响因子: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN 打印: 1064-2285
ISSN 在线: 2162-6561

传热学

DOI: 10.1615/HeatTransRes.2014007055
pages 195-211

HEAT TRANSFER CHARACTERISTICS OF THE MULTITHREADED HELICALLY COILED TUBE GENERATOR USED IN THE ABSORPTION−COMPRESSION HYBRID REFRIGERATION CYCLE

Jianbo Li
Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, School of Energy and Power, Dalian University of Technology, Dalian, China
Shiming Xu
Dalian University of Technology, 2 Ling Gong Rd. Gan Jingzi District, Dalian 116024, China
Shaokang Kong
Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, School of Energy and Power, Dalian University of Technology, Dalian, China

ABSTRACT

The generator is a key device in the absorption−compression hybrid refrigeration cycle (ACH-RC). Multithreaded helically coiled tubes were used in the generator as heat exchanging elements. The heat transfer characteristic of the coil generator has been inadequately researched because of the complicated character of heat transfer between the gases from engines and the working fluid in the helically coiled tube generator. This article attempts at discussing this by numerical simulation. First, the construction parameters of the coil generator were confirmed by CFD simulation under the limited resistance to flowing gases. Then, the heat transfer models of the coil generator were developed based on some simplifications and assumptions. The heat transfer characteristic of the coil generator was simulated by difference calculus. The results show that the heat transfer area, efficient heat exchange height of the coil generator are 2.24 m2 and 0.784 m, respectively. While the engine output reaches 180 kW, the heat transfer load of the coil generator can meet the requirement of 58.68 kW which is the load for the cooling capacity provided fully by the absorption refrigeration subcycle (ARSC). The pressure drop in the gas flowing through the coil generator is 1.65 kPa.


Articles with similar content:

EXPERIMENTAL TESTING OF A SMALL-SCALE SOLAR THERMAL BRAYTON CYCLE RECUPERATOR
International Heat Transfer Conference 16, Vol.13, 2018, issue
Willem G. Le Roux, Josua Petrus Meyer, Kyle E. Dellar
THEORETICAL AND EXPERIMENTAL STUDY ON ONE NONTHROTTLING METHOD IN PUMPFLOW MEASURING AND MONITORING
Energy and Environment, 1995, Vol.0, 1995, issue
De Yuan, LiangYu Ma, SongLing Wang, LianSuo An
DEVELOPMENT OF A NEW LARGE-FLOW-RATE AND EFFICIENT MIST GENERATOR, AND ITS APPLICATION TO AIR COOLING IN GREENHOUSES
Multiphase Science and Technology, Vol.22, 2010, issue 1
Naoki Tanaka, Fuminori Matsuyama, Akimaro Kawahara, Kentarou Fukamachi, Michio Sadatomi
OPTIMIZATION OF SOLAR CAVITY RECEIVER FOR CROSS LINEAR CONCENTRATED SOLAR POWER SYSTEM – A NUMERICAL STUDY
International Heat Transfer Conference 16, Vol.20, 2018, issue
Hiroshige Kikura, Kentaro Kanatani, Hideharu Takahashi, Rendy Silva Renata, Yutaka Tamaura
THERMODYNAMIC ASSESSMENT OF ORGANIC RANKINE CYCLE SYSTEMS DURING OFF-DESIGN OPERATION IN COMBINED HEAT AND POWER (CHP) APPLICATIONS
3rd Thermal and Fluids Engineering Conference (TFEC), Vol.1, 2018, issue
Maria Anna Chatzopoulou, Christos N. Markides