图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
强化传热期刊
影响因子: 0.562 5年影响因子: 0.605 SJR: 0.211 SNIP: 0.361 CiteScore™: 0.33

ISSN 打印: 1065-5131
ISSN 在线: 1026-5511

强化传热期刊

DOI: 10.1615/JEnhHeatTransf.v17.i1.50
pages 77-92

Experimental Study of Heat Transfer and Friction in Annular Ducts with a Heated Tube Having a Spirally Wound Helical Spring

Rajendra Karwa
Department of Mechanical Engineering, Faculty of Engineering and Architecture, Jai Narain Vyas University, Jodhpur 342 011, India
B. K. Maheshwari
Department of Mechanical Engineering, Faculty of Engineering and Architecture, Jai Narain Vyas University, Jodhpur 342 011, India
Shailesh K. Patel
Department of Mechanical Engineering, Faculty of Engineering and Architecture, Jai Narain Vyas University, Jodhpur 342 011, India

ABSTRACT

The paper presents results of an experimental investigation carried out to study the effect of relative roughness pitch and perforation of the spring roughness (by changing coil pitch of the helical spring) on heat transfer and friction factor for turbulent flow in an asymmetrically heated annular duct (radius ratio = 0.39) with a heated tube having a spirally wound helical spring. The spring diameter to hydraulic diameter ratio is 0.11. The relative roughness pitch ranges from 4.09 to 8.18, while the relative coil pitch is 2.66−4.5. The maximum enhancement in the Nusselt number over the smooth annulus ranges from 95 to 172% for Spring 2 (with a relative coil pitch, pc/d, of 2.66 arranged at a relative roughness pitch, p/e, of 4) while the lowest enhancement of 54−81% is seen for Spring 12 (pc/d = 4.5; p/e = 8) in the flow Reynolds number range of about 4000−14,000; the Nusselt number ratio, Nu/Nus, has been found first to increase with an increase in the Reynolds number up to about 10,000 and then decrease. The corresponding enhancement in the friction factor values is 193−307% and 116−137%, respectively. Thermal performance comparison at equal pumping power for the roughened and smooth annuli shows performance advantage of 32−83% for Spring 2. Nusselt number and friction factor correlations have been developed for the most preferred type of roughness.


Articles with similar content:

PRESSURE DROP AND HEAT TRANSFER IN SPIRALLY CORRUGATED TUBE FOR A COUNTER-FLOW HEAT EXCHANGER
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2012, issue
Anchasa Pramuanjaroenkij, Apichart Chaengbamrung , Amarin Tongkratoke
Experimental and Numerical Investigation of Thermal-Hydraulic Characteristics of a Wavy-Channel Compact Heat Exchanger
International Heat Transfer Conference 12, Vol.52, 2002, issue
Raj M. Manglik, Arun Muley, Joseph B. Borghese, Jaydeep Kundu
EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER ENHANCEMENT FROM MULTIPLE DIMPLED SURFACES IN RECTANGULAR CHANNEL
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017), Vol.0, 2017, issue
Sandeep S. Kore, Sunil V. Dingare, Sachin G. Ilag
Experimental Study of the Effects of Rib Angle and Discretization on Heat Transfer and Friction in an Asymmetrically Heated Rectangular Duct
Journal of Enhanced Heat Transfer, Vol.12, 2005, issue 4
Nitin Karwa, Rajendra Karwa, B. P. Jain, R. D. Bairwa
Heat transfer and pressure drop in tubes equipped with coiled wire turbulence promoters
International Heat Transfer Conference 12, Vol.47, 2002, issue
Wladimir Linzer, Karl Ponweiser, Marina Malinovec