ISSN 打印: 0276-1459
ISSN 在线: 1943-6181
卷 31, 2019
卷 30, 2018
卷 29, 2017
卷 28, 2016
卷 27, 2015
卷 26, 2014
卷 25, 2013
卷 24, 2012
卷 23, 2011
卷 22, 2010
卷 21, 2009
卷 20, 2008
卷 19, 2007
卷 18, 2006
卷 17, 2005
卷 16, 2004
卷 15, 2003
卷 14, 2002
卷 13, 2001
卷 12, 2000
卷 11, 1999
卷 10, 1998
卷 9, 1997
卷 8, 1994
卷 7, 1993
卷 6, 1992
卷 5, 1990
卷 4, 1989
卷 3, 1987
卷 2, 1986
卷 1, 1982
BOILING HEAT TRANSFER IN A VERTICAL MICROCHANNEL: LOCAL ESTIMATION DURING FLOW BOILING WITH A NON INTRUSIVE METHOD
Polytech' Marseille Laboratoire IUSTI-UMR/CNRS 6595, 5, Rue Enrico Fermi, Technopole de Chateau-Gombert, 13453 Marseille cedex 13, France
Aix Marseille University, CNRS, IUSTI UMR 7343, 13013, Marseille, France; Institut Universitaire de France, 75231 Paris, France
Christophe Le Niliot
Aix-Marseille Université,IUSTI UMR 7343 CNRS
Aix-Marseille Universite, CNRS, Laboratoire IUSTI, UMR 7343, Marseille 13453, France
Laboratoire LTPMP, Fac GMGP, USTHB, 16111, Bab Ezzouar, Algiers, Algeria
This paper summarizes the results of experimental and umerical studies concerning boiling heat transfer inside vertical minichannels. The objective here is to provide basic knowledge on the systems of biphasic cooling in minichannels for several gravity levels (μg, 1g, 2g). To fully understand the high heat transfer potential of boiling flows in microscale's geometry, it is vital to quantify these transfers. To achieve this goal, an experimental device has been set up and, in order to study the influence of gravity, the device has been embarked on board A300 Zero-G to make Parabolic Flights experiments. Analysis is made up by using an inverse method in order to estimate the local heat coefficient while boiling occurs inside a minichannel. The results concern two-phase flow during convective boiling, and this investigation leads to solving an inverse heat conduction problem (IHCP). The estimation consists of inversing experimental data measurements located in the heating rod of our experiment to obtain the wall temperature and the heat flux on the minichannel surface. Images and video sequences have been performed with a high-speed camera. The experiments are conducted with HFE-7100 because this fluid has a low boiling temperature at the cabin pressure of the A300. This choice was governed by the capillary length, which is 4.3 mm in microgravity (0.05 m s-2). The experimental loop allows control of the heat flux and the liquid flow rate for three hydraulic diameters (DH): 0.49, 0.84, and 1.18 mm. The influence of three different parameters on the heat transfer coefficient are carried out: the gravity level, the Reynolds number, and the vapor quality. First results show that whatever the gravity level, the local heat transfer decreases sharply from the inlet to the outlet channel. In the annular slug regime, the average heat transfer is found around 6000 W m-2 K-1 and we observe that the heat transfer coefficient is higher in microgravity (30%) compared to normal and hypergravity conditions.
Alifanov, O. M.,
Inverse Heat Transfer Problems.
Aligoodarz, M., Yan, Y., and Kenning, D.,
Wall temperature and pressure variations during flow boiling in narrow channels.
Beck, J. V., Blackwell, B., and Clair, C. R.,
Inverse Heat Conduction.
Bergles, A. E. Lienhard, V. J. H., Kendall, G. E., and Griffith, P.,
Boiling and evaporation in small diameter channels.
Brebbia, C. A., Telles, J. C. F., and Wrobel, L. C,
Boundary Element Techniques.
Brutin, D. and Tadrist, L.,
Destabilization mechanisms and scaling laws of convective boiling in a minichannel.
Carey, V. P.,
Liquid-Vapor Phase-Change Phenomena.
Celata, G. P., Cumo, M., Gulielmi, M., and Zummo, G.,
Experimental investigation of hydraulic and single phase heat transfer in 0.130 mm capillary tube.
Dulikravitch, G. S. and Martin, T. J.,
Inverse determination of boundary conditions and sources in steady heat conduction with heat generation.
Hansen, P. C.,
Rank-Deficient and Discrete Ill-Posed Problems.
Hestroni, G., Mosyak, A., Progrebnyak. E., and Yarin, L. P.,
Fluid flow in microchannels.
Jiang, L., Wong, M., and Zohar, Y.,
Phase change in microchannel heat sink under forced convection boiling.
Kandlikar, S. G.,
Fundamental issues related to flow boiling in minichannels and microchannels.
Kennedy, J. E., Roach, G. M., Dowling, M. F., Abdel-Khalik, S. I., Ghiaasiaan, S. M., Jeter, S. M., and Quershi, Z. H.,
The onset of flow instability in uniformly heated horizontal microchannels.
Kew, P. A. and Cornwell, K.,
Confined bubble flow and boiling in narrow spaces.
Kew, P. A. and Cornwell, K.,
On pressure fluctuations during boiling in narrow channels.
Kew, P. A. and Cornwell, K.,
Correlations for the prediction of boiling heat transfer in small-diameter channels.
Instability flow during natural forced circulation.
Lesnic, D., Elliott, L., and Ingham, D. B.,
Application of the boundary element method to inverse heat conduction problems.
Le Niliot, C. and Lefevre, F.,
A method for multiple steady line heat sources identification in a diffusive system: Application to an experimental 2D problem.
Pasquetti R. and Le Niliot, C.,
Boundary element approach for inverse conduction problems: application to a bidimensional transient numerical experiment.
Peng, X. F. and Wang, B. X.,
Forced-convection and boiling characteristics in microchannels.
Press, W. H., Flannery, B. P., Teulossky, S. A., and Vetterling, W. T.,
Qu, W. and Mudawar, I.,
Flow boiling heat transfer in two-phase micro-channel heat sinks: Experimental investigation and assessement of correlations methods.
Tadrist, L., Luciani, S., Brutin, D., Rahli, O., and Niliot, C. L.,
Flow boiling in microgravity condition: Investigation using inversetechniques.
Boiling in microchannels: A review of experiment and theory.
Tikhonov, A. N. and Arsenin, V. Y.,
Solutions of Ill-Posed Problems.
Tuckerman, D. B. and Pease, R. F. W.,
High-Performance Heat Sinking for VLSI.
Wambsganss, M. W., Tran, T. N., and France, D. M.,
Small circular and rectangular channel boiling with two refrigerants.
Yan, Y. and Kenning, D. B. R.,
Pressure flucutations during boiling in a narrow channel.
The determination of two heat sources in an inverse heat conduction problem.