图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
国际多尺度计算工程期刊
影响因子: 1.016 5年影响因子: 1.194 SJR: 0.554 SNIP: 0.68 CiteScore™: 1.18

ISSN 打印: 1543-1649
ISSN 在线: 1940-4352

国际多尺度计算工程期刊

DOI: 10.1615/IntJMultCompEng.v4.i5-6.110
pages 771-790

On the Implementation of Plane Stress in Computational Multiscale Modeling

Robert Lillbacka
FS Dynamics, Molndalsvagen 24, SE-412 63 Goteborg; Chalmers University of Technology, Department of Applied Mechanics, SE-412 96 Göteborg; and Swedish National Testing and Research Institute (SP), Brinellgatan 4, Box 857, SE-50115 Borås, Sweden
Fredrik Larsson
Department of Applied Mechanics, Chalmers University of Technology, S-412 96 Gothenburg
Kenneth Runesson
Department of Structural Mechanics Chalmers, University of Technology S-41296 Goteborg, Sweden

ABSTRACT

Different aspects of the plane stress condition in concurrent two-scale computational (first-order) homogenization are discussed. The basic ingredient in computational homogenization is the calculation of the macroscale stress, for given macroscale deformation, via computations on a representative volume element (RVE). Two modeling assumptions are compared: The subscale (Hill-type) and macroscale-type (Taylor-type) plane stress conditions. The corresponding iterative strategies and the macroscale algorithmic tangent operators are derived using the primal (conventional) approach. The performance of the various iterative strategies are compared for a single RVE problem as well as in a fully concurrent analysis of a complex substructure (duplex stainless steel) under realistic subscale modeling based on crystal plasticity with hardening.


Articles with similar content:

ERROR CONTROLLED USE OF THE TAYLOR ASSUMPTION IN ADAPTIVE HIERARCHICAL MODELING OF DSS
International Journal for Multiscale Computational Engineering, Vol.13, 2015, issue 2
Robert Lillbacka, Kenneth Runesson, Fredrik Larsson
Multiscale Analysis of Microstructural Evolution and Degradation in Solder Alloys
International Journal for Multiscale Computational Engineering, Vol.5, 2007, issue 2
M. Erinc, R. L. J. M. Ubachs, P. J. G. Schreurs, W. P. Vellinga, Marc Geers, M. A. Matin
PERTURBATION-BASED STOCHASTIC MICROSCOPIC STRESS ANALYSIS OF A PARTICLE-REINFORCED COMPOSITE MATERIAL VIA STOCHASTIC HOMOGENIZATION ANALYSIS CONSIDERING UNCERTAINTY IN MATERIAL PROPERTIES
International Journal for Multiscale Computational Engineering, Vol.9, 2011, issue 4
F. Ashida, Sei-ichiro Sakata, K. Enya
Multilevel Parallel Programming for Multiscale Modeling of Composite Materials
International Journal for Multiscale Computational Engineering, Vol.2, 2004, issue 3
Somnath Ghosh, Paul M. Eder, James E. Giuliani
TWO-SCALE NUMERICAL HOMOGENIZATION OF THE CONSTITUTIVE PARAMETERS OF REACTIVE POWDER CONCRETE
International Journal for Multiscale Computational Engineering, Vol.12, 2014, issue 5
Arkadiusz Denisiewicz, Mieczyslaw Kuczma