图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
国际计算热科学期刊
ESCI SJR: 0.249 SNIP: 0.434 CiteScore™: 1.4

ISSN 打印: 1940-2503
ISSN 在线: 1940-2554

国际计算热科学期刊

DOI: 10.1615/ComputThermalScien.2015014345
pages 489-507

NUMERICAL INVESTIGATION OF ROUND TURBULENT SWIRLING JET IMPINGEMENT HEAT TRANSFER FROM A HOT SURFACE

Muhammad Ali Rob Sharif
Aerospace Engineering and Mechanics Department, The University of Alabama, Tuscaloosa, Alabama, USA

ABSTRACT

Numerical investigation of heat transfer from a heated plane circular surface due to round turbulent submerged swirling jet impingement is conducted in this study. A round swirling turbulent jet is impinging normally on a concentric circular hot plane surface. The axisymmetric flow domain is bounded by the hot impingement surface and the jet exit plane. The flow is characterized by the jet exit Reynolds number (Re), the jet exit swirl number (Sw) representing the swirl strength of the inlet flow, and the nondimensional distance of separation from the jet exit to the impingement plate (H). The commercial CFD code ANSYS Fluent along with the transition SST k-ω turbulence model is used for the computations. In order to select a suitable turbulence model for the computations, the performance of a few turbulence models in the computation of round impinging jet heat transfer were validated against experimental data, and the transition SST k-ω model was selected. Computations are performed for many arrangements of the above-mentioned parameters and critical analysis of the heat transfer process is performed. The results indicate negative effect on heat transfer when swirl is present. For low- to mid-range swirl strength when Sw ≤ 0.77, the average Nusselt number drops mildly as Sw is increased from 0 (nonswirling case). When Sw ≥ 1, the average Nusselt number increases mildly with increasing Sw but remains less than that for the nonswirling case. Also when Sw ≤ 0.77, the average Nusselt number increases mildly with increasing jet-to-target separation distance (2 ≤ H ≤ 10). On the other hand, when Sw ≥ 1.00, the average Nusselt number moderately drops as H increases.


Articles with similar content:

NUMERICAL ANALYSIS OF HEAT TRANSFER FROM A HOT PLANE SURFACE DUE TO TURBULENT SWIRLING ROUND JET IMPINGEMENT
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2015, issue
Muhammad Ali Rob Sharif
EFFECT OF RADIAL INNER CYLINDER VIBRATION ON TAYLOR-COUETTE FLOW WITH FREE SURFACE
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2014, issue
Hamid Oualli, Ahcene Bouabdallah, Ali Abdelali, Mahmoud Mekadem
NUMERICAL INVESTIGATION OF IMPINGING HEAT TRANSFER AND FLUID FLOW DUE TO A TURBULENT ANNULAR JET
3rd Thermal and Fluids Engineering Conference (TFEC), Vol.6, 2018, issue
Farhana Afroz, Muhammad Ali Rob Sharif
FLOW AND HEAT TRANSFER DUE TO IMPINGING ANNULAR JET
International Journal of Fluid Mechanics Research, Vol.46, 2019, issue 3
Himadri Chattopadhyay, TARUN KANTI PAL, Dipak Kumar Mandal
Effects of interval of spanwise-modulated local forcing on mechanisms of flow separation control
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2015, issue
Kozo Fujii, Soshi Kawai, Taku Nonomura, A. Yakeno, Y. Abe