图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
雾化与喷雾
影响因子: 1.262 5年影响因子: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN 打印: 1044-5110
ISSN 在线: 1936-2684

卷:
卷 29, 2019 卷 28, 2018 卷 27, 2017 卷 26, 2016 卷 25, 2015 卷 24, 2014 卷 23, 2013 卷 22, 2012 卷 21, 2011 卷 20, 2010 卷 19, 2009 卷 18, 2008 卷 17, 2007 卷 16, 2006 卷 15, 2005 卷 14, 2004 卷 13, 2003 卷 12, 2002 卷 11, 2001 卷 10, 2000 卷 9, 1999 卷 8, 1998 卷 7, 1997 卷 6, 1996 卷 5, 1995 卷 4, 1994 卷 3, 1993 卷 2, 1992 卷 1, 1991

雾化与喷雾

DOI: 10.1615/AtomizSpr.v19.i1.30
pages 41-56

PERFORMANCE CHARACTERISTICS OF EFFERVESCENT ATOMIZER IN DIFFERENT FLOW REGIMES

K. Ramamurthi
Thermodynamics and Combustion Laboratory, Indian Institute of Technology, Madras, Chennai 600036, India
U. K. Sarkar
Thermodynamics and Combustion Laboratory, Indian Institute of Technology, Madras, Chennai 600036, India
B. N. Raghunandan
Department of Aerospace Engineering, Indian Institute of Science, Bangalore 560012, India

ABSTRACT

The characteristics of the two-phase flow and the spray formed in an effervescent atomizer were experimentally investigated over a range of flow rates, gas-to-liquid ratios (GLR), injection pressures, and discharge orifice diameters. The Reynolds number (Re), defined with the orifice diameter as the characteristic length, was seen to be a pertinent parameter in addition to GLR for determining the transition from the bubbly flow to slug flow. The discharge coefficient of the atomizer in the bubbly flow regime and the Sauter mean diameter of the spray in the annular flow regime were found to scale with the parameter {GLR (Re)0.5}. The structure of the spray and the measured values of cone angle of the spray showed distinctly different features in the bubbly, slug, and annular flow regimes. A two-dimensional simulation of the flow and spray structure reproduced the gross features observed in the experiments.


Articles with similar content:

NUMERICAL STUDIES OF THE FLOW STRUCTURE IN THE FINAL DISCHARGE ORIFICE OF EFFERVESCENT ATOMIZER
Atomization and Sprays, Vol.22, 2012, issue 3
Lingyong Pan, Gang Yang, Baoren Li
CHARACTERISTICS OF SPRAYS THROUGH A WALL IMPINGEMENT INJECTOR
Atomization and Sprays, Vol.14, 2004, issue 4
Takao Inamura, Terutoshi Tomoda
PULSATING SLURRY ATOMIZATION, FILM THICKNESS, AND AZIMUTHAL INSTABILITIES
Atomization and Sprays, Vol.28, 2018, issue 7
Wayne Strasser, Francine Battaglia
MASS DISTRIBUTION STUDIES IN EFFERVESCENT SPRAYS
Atomization and Sprays, Vol.21, 2011, issue 5
Ali Dolatabadi, Hrishikesh Gadgil, B. N. Raghunandan
EFFERVESCENT ATOMIZATION AT LOW MASS FLOW RATES. PART I: THE INFLUENCE OF SURFACE TENSION
Atomization and Sprays, Vol.3, 1993, issue 1
Paul E. Sojka, P. G. Gosselin, Arthur H. Lefebvre, M. T. Lund