图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
雾化与喷雾
影响因子: 1.737 5年影响因子: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN 打印: 1044-5110
ISSN 在线: 1936-2684

卷:
卷 30, 2020 卷 29, 2019 卷 28, 2018 卷 27, 2017 卷 26, 2016 卷 25, 2015 卷 24, 2014 卷 23, 2013 卷 22, 2012 卷 21, 2011 卷 20, 2010 卷 19, 2009 卷 18, 2008 卷 17, 2007 卷 16, 2006 卷 15, 2005 卷 14, 2004 卷 13, 2003 卷 12, 2002 卷 11, 2001 卷 10, 2000 卷 9, 1999 卷 8, 1998 卷 7, 1997 卷 6, 1996 卷 5, 1995 卷 4, 1994 卷 3, 1993 卷 2, 1992 卷 1, 1991

雾化与喷雾

DOI: 10.1615/AtomizSpr.v16.i5.20
pages 493-510

CHARACTERISTICS OF TRANSIENT, SWIRL-GENERATED, HOLLOW-CONE SPRAYS

Julian T. Kashdan
I.F.P., Rueil-Malmaison, France
John S. Shrimpton
Energy Technology Research Group, School of Engineering Sciences, University of Southampton, United Kingdom, SO171BJ

ABSTRACT

The near-nozzle, global, spatial, and temporal characteristics of a hollow-cone spray produced by a pressure swirl-type atomizer have been investigated experimentally. Particular attention is given to the transient phase just after needle opening, which, for pulsed or intermittent atomizers, plays an all-important role in defining the global spray behavior and, more significantly, atomization quality. Qualitative and quantitative spray measurements have been achieved via the combined diagnostic techniques of high-magnification charge-coupled device (CCD) imaging and phase Doppler anemometry (PDA), which provides useful data not only in terms of improving the design and performance of pressure swirl atomizers, but also for the validation and refinement of numerical spray models. High-magnification CCD images of the intact near-nozzle liquid sheet reveal a certain degree of helical swirl motion, although laser Doppler velocimetry (LDV) results indicate that the tangential swirl motion imparted on the liquid sheet decays rapidly within the first few millimeters of the atomizer orifice to near-negligible levels. Images of the poorly atomized “preswirl spray” formed during the early transient phase of injection also revealed the presence of large, nonspherical liquid masses up to 1 mm in size, even as far as 72 nozzle diameters downstream. The spray-induced gas phase flow, which results in the characteristic toroidal vortex, was found to have a significant influence on droplet trajectories and segregation of the fast-moving large (D32 between 25 and 30 μm) and small (1−5 μm) droplets within the spray. Estimates of characteristic droplet Weber numbers have also been made, which, in general, were found to be less than the critical values required for secondary droplet breakup to occur.


Articles with similar content:

STRUCTURE OF A NONEVAPORATING SWIRL INJECTOR SPRAY
Atomization and Sprays, Vol.7, 1997, issue 1
Richard Eskridge, Douglas A. Feikema, John J. Hurt
THE PERFORMANCE CHARACTERISTICS OF SOLID-CONE-SPRAY PRESSURE-SWIRL ATOMIZERS
Atomization and Sprays, Vol.10, 2000, issue 6
D. D. James, J. R. Jeong, R. A. Sharief
DEVELOPMENT AND VALIDATION OF A CASCADE ATOMIZATION AND DROP BREAKUP MODEL FOR HIGH-VELOCITY DENSE SPRAYS
Atomization and Sprays, Vol.14, 2004, issue 3
Franz X. Tanner
MODELING THE EFFECTS OF GAS DENSITY ON THE DROP TRAJECTORY AND BREAKUP SIZE OF HIGH-SPEED LIQUID DROPS
Atomization and Sprays, Vol.9, 1999, issue 5
Rolf D. Reitz, C. H. Lee
MECHANISMS OF AIR-ASSISTED LIQUID ATOMIZATION
Atomization and Sprays, Vol.3, 1993, issue 1
Rolf D. Reitz, A. B. Liu