图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
雾化与喷雾
影响因子: 1.737 5年影响因子: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 2.2

ISSN 打印: 1044-5110
ISSN 在线: 1936-2684

卷:
卷 30, 2020 卷 29, 2019 卷 28, 2018 卷 27, 2017 卷 26, 2016 卷 25, 2015 卷 24, 2014 卷 23, 2013 卷 22, 2012 卷 21, 2011 卷 20, 2010 卷 19, 2009 卷 18, 2008 卷 17, 2007 卷 16, 2006 卷 15, 2005 卷 14, 2004 卷 13, 2003 卷 12, 2002 卷 11, 2001 卷 10, 2000 卷 9, 1999 卷 8, 1998 卷 7, 1997 卷 6, 1996 卷 5, 1995 卷 4, 1994 卷 3, 1993 卷 2, 1992 卷 1, 1991

雾化与喷雾

DOI: 10.1615/AtomizSpr.v13.i1.30
18 pages

DIESEL FUEL SPRAY DROPLET SIZES AND VOLUME FRACTIONS FROM THE REGION 25 MM BELOW THE ORIFICE

Jennifer Labs
Division of Engineering, Colorado School of Mines, Golden, Colorado, USA
Terry Parker
Florida Polytechnic University, Lakeland, FL 33805, USA

ABSTRACT

Droplet diameter and volume fraction measurements are reported for three different fuels (diesel fuel, dodecane, and methyl oleate) as a/unction of radial position within a pressure-atomized spray typical of diesel systems. Injection system parameters were peak pressures of 62 MPa and a single-orifice injector with a 0.31-mm orifice diameter and an L/D ratio of approximately 2. Results are for individual injection events into atmospheric-pressure and ambient-temperature air at an axial distance of 25 mm from the nozzle. Measurements relied on infrared scattering, which was specifically chosen due to the high droplet number densities of these sprays. Details of the measurement technique are presented along with results. Results indicate droplet diameters are the smallest at the spray centerline (2-3.25 mm), and grow with radial distance from the centerline (6-8 mm at the spray periphery). Volume fractions greater than 1% are seen at the spray centerline, and, once the spray has developed, the majority of the mass is contained in the central 0.75-mm-radial region. Spray details presented include the definition of transient time periods for the spray, the spray width as a function of time, the coupling between injection pressure and observed diameters (SMD) and volume fractions, and the differences in the spray properties as a function of fuel type.


Articles with similar content:

DIESEL FUEL SPRAY DROPLET SIZES AND VOLUME FRACTIONS FROM THE REGION 25 MM BELOW THE ORIFICE
Atomization and Sprays, Vol.13, 2003, issue 5&6
Terry Parker, Jennifer Labs
TWO-DIMENSIONAL DROPLET SIZE AND VOLUME FRACTION DISTRIBUTIONS FROM THE NEAR-INJECTOR REGION OF HIGH-PRESSURE DIESEL SPRAYS
Atomization and Sprays, Vol.16, 2006, issue 7
Terry Parker, Jennifer Labs
DIESEL SPRAY IMPINGING ON A FLAT WALL. PART II: VOLUME AND AVERAGE AIR-FUEL RATIO OF AN IMPINGEMENT DIESEL SPRAY
Atomization and Sprays, Vol.12, 2002, issue 5&6
Masataka Arai, Kyungnam Ko
CHARACTERISTICS OF ADHESION DIESEL FUEL ON AN IMPINGEMENT DISK WALL. PART 3: AMBIENT PRESSURE EFFECT
Atomization and Sprays, Vol.24, 2014, issue 7
Masataka Arai, Yoshio Zama, Tomohiko Furuhata, Mohd Zaid Akop
THE EFFECT OF FLASH BOILING ON THE ATOMIZATION PERFORMANCE OF GASOLINE DIRECT INJECTION MULTISTREAM INJECTORS
Atomization and Sprays, Vol.24, 2014, issue 6
Jerome Helie, Graham Wigley, Mehdi Mojtabi