图书馆订阅: Guest
Begell Digital Portal Begell 数字图书馆 电子图书 期刊 参考文献及会议录 研究收集
雾化与喷雾
影响因子: 1.262 5年影响因子: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN 打印: 1044-5110
ISSN 在线: 1936-2684

卷:
卷 29, 2019 卷 28, 2018 卷 27, 2017 卷 26, 2016 卷 25, 2015 卷 24, 2014 卷 23, 2013 卷 22, 2012 卷 21, 2011 卷 20, 2010 卷 19, 2009 卷 18, 2008 卷 17, 2007 卷 16, 2006 卷 15, 2005 卷 14, 2004 卷 13, 2003 卷 12, 2002 卷 11, 2001 卷 10, 2000 卷 9, 1999 卷 8, 1998 卷 7, 1997 卷 6, 1996 卷 5, 1995 卷 4, 1994 卷 3, 1993 卷 2, 1992 卷 1, 1991

雾化与喷雾

DOI: 10.1615/AtomizSpr.2015011504
pages 1025-1045

INFLUENCE OF EMULSIONS AND STEAM INJECTION ON A DIESEL FUELED MODEL GAS TURBINE COMBUSTOR

Meagan Sung
UCI Combustion Laboratory, University of California, Irvine, California 92697-3550, USA
Vincent McDonell
Department of Mechanical and Aerospace Engineering, University of California at Irvine, USA

ABSTRACT

The introduction of water into a combustion chamber can mitigate NOX emissions because water's high specific heat allows it to act as a heat sink to reduce system temperatures. This effort compared the relative effects on combustion performance when introducing water into the combustion air compared to injection with the fuel as a diesel fuel−water emulsion. In this study, a pressure simplex nozzle was used to inject the fuel or emulsion. For this study, fuel was injected in a non-premixed (i.e., lean direct injection) fashion and an axisymmetric model gas turbine combustor was used. To complement the combustion studies, an assessment of how mixing the fuel with water impacted atomization behavior was also conducted. Increasing the water to fuel mass ratio (W/F) did not significantly affect the stability of steam injection flames, but it did significantly decrease the stability of emulsion flames. For a given amount of water added, emulsions were more effective at reducing NOX than water introduced into the combustion air. Investigation of emulsion atomization properties showed little change in droplet size and spray angle with increasing W/F, but faster sheet breakup was observed for the cone spray produced by the simplex nozzle used. Dual-wavelength planar laser induced fluorescence (D-PLIF) showed that water tends to locate away from the spray centerline, resulting in a nonuniform radial profile of local W/F. However, it is also observed that an increase in the overall W/F ratio leads to a more uniform radial profile of local W/F. OH* chemiluminescence and flame imaging showed a decrease in the average chemiluminescent intensity and a bimodal trend inflame length behavior. The changes in these characteristics were more extreme for the emulsion reactions, which can most likely be attributed to the water in the emulsion cases evaporating within the reaction zone and the overall higher amount of water interacting with the reaction zone for these overall lean reactions.


Articles with similar content:

EFFECT OF AIR INJECTION CONFIGURATION ON THE ATOMIZATION OF GELLED JET A1 FUEL IN AN AIR-ASSIST INTERNALLY MIXED ATOMIZER
Atomization and Sprays, Vol.23, 2013, issue 4
Debi Prasad Mishra, Manisha B. Padwal
A NEW DOUBLE-SLIT CURVED WALL-JET (CWJ) BURNER FOR STABILIZING TURBULENT PREMIXED AND NON-PREMIXED FLAMES
TSFP DIGITAL LIBRARY ONLINE, Vol.9, 2015, issue
Morkous S. Mansour, Suk Ho Chung
COMPARISON OF WATER-IN-OIL EMULSION ATOMIZATION CHARACTERISTICS FOR LOW- AND HIGH-CAPACITY PRESSURE-SWIRL NOZZLES
Atomization and Sprays, Vol.21, 2011, issue 5
Christopher D. Bolszo, William A. Sirignano, Adrian A. Narvaez, Vincent McDonell, Derek Dunn-Rankin
EFFECTS OF ACCESS OF SECONDARY AIR ON OPERATION OF AN ATMOSPHERIC BURNER
International Journal of Energy for a Clean Environment, Vol.12, 2011, issue 1
Dimosthenis Trimis, Goran Mrazic, Franz von Issendorff, Sabine Ausmeier, Ana Zbogar-Rasic
COMBUSTION AND EMISSION CHARACTERISTICS OF RESIDUAL OIL WITH ADDITIVE OF ORGANIC BARIUM
Proceedings of Symposium on Energy Engineering in the 21st Century (SEE2000) Volume I-IV, Vol.0, 2000, issue
M. J. Chen, Tsong-Sheng Lee