Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
Journal of Porous Media
Impact-faktor: 1.49 5-jähriger Impact-Faktor: 1.159 SJR: 0.504 SNIP: 0.671 CiteScore™: 1.58

ISSN Druckformat: 1091-028X
ISSN Online: 1934-0508

Volumes:
Volumen 22, 2019 Volumen 21, 2018 Volumen 20, 2017 Volumen 19, 2016 Volumen 18, 2015 Volumen 17, 2014 Volumen 16, 2013 Volumen 15, 2012 Volumen 14, 2011 Volumen 13, 2010 Volumen 12, 2009 Volumen 11, 2008 Volumen 10, 2007 Volumen 9, 2006 Volumen 8, 2005 Volumen 7, 2004 Volumen 6, 2003 Volumen 5, 2002 Volumen 4, 2001 Volumen 3, 2000 Volumen 2, 1999 Volumen 1, 1998

Journal of Porous Media

DOI: 10.1615/JPorMedia.v12.i10.20
pages 939-954

Highly Porous Metal Foams: Effective Thermal Conductivity Measurement Using a Photothermal Technique

Mourad Fetoui
Ecole Nationale d'Ingénieurs de Monastir, Laboratoire d'Etudes des Systèmes Thermiques et Energétiques, Avenue Ibn Eljazzar, 5019 Monastir, Tunisie
Fethi Albouchi
Laboratoire d'Etudes des Systèmes Thermiques et Energétiques, Ecole Nationaled 'Ingénieurs de Monastir, Tunisia
Fabrice Rigollet
Aix Marseille Univ, CNRS, IUSTI
Sassi Ben Nasrallah
Laboratoire d'Études des Systèmes Thermiques et Énergétiques, Ecole Nationale d'Ingénieurs de Monastir, Monastir 5019 Tunisie

ABSTRAKT

The effective thermal conductivity of highly porous metal foams is measured using a photothermal method with a crenel heating excitation. This method is based on a nondestructive technique. The foam is sandwiched between two thin aluminum plates. The front face of the three-layered structure is submitted to a heat flux and the temperature rise on the rear face is recorded using an infrared camera. Measurements are reported on several foams. The parameter identification is performed by the minimization of the ordinary least squares objective function comparing the measured temperatures to the response of a thermal model function of thermophysical parameters, built with thermal quadruple formalism. The used iterative algorithm is based on the Gauss-Newton method. The obtained results are compared to the literature values and a good agreement is noted.


Articles with similar content:

Measurement of the Effective Thermal Conductivity of Powders Using a Three-Layer Structure
Journal of Porous Media, Vol.10, 2007, issue 6
Sassi Ben Nasrallah, Fethi Albouchi, Foued Mzali
Optimal Experiment Design and Measurement of the Effective Thermal Conductivity of a Porous Medium in the Presence of Free Convection
Journal of Porous Media, Vol.12, 2009, issue 6
Abdelmajid Jemnia, Sami Znaidia, Sassi Ben Nasrallah, Fethi Albouchi, Foued Mzali
EXPERIMENTAL METHOD FOR MEASURING THE SPECTRAL TRANSMITTANCE OF ALUMINA FOAM AT HIGH TEMPERATURES
International Heat Transfer Conference 16, Vol.22, 2018, issue
Shun-De Zhang, Chuang Sun, Li-Ming Ruan, Xin-Lin Xia, Feng-Xian Sun
EFFECTIVE OPTICAL PROPERTIES OF ABSORBING NANOCOMPOSITE THIN FILMS FOR TE AND TM POLARIZATION
ICHMT DIGITAL LIBRARY ONLINE, Vol.17, 2007, issue
Ashcon Navid, Laurent Pilon
DETERMINATION OF THE RADIATION CHARACTERISTICS OF RETICULATE POROUS CERAMICS BY EXPERIMENTAL SPECTROSCOPY AND TOMOGRAPHY-BASED MONTE CARLO
ICHMT DIGITAL LIBRARY ONLINE, Vol.17, 2007, issue
Aldo Steinfeld, Wojciech Lipinski, P. Coray