Erscheint 8 Ausgaben pro Jahr
ISSN Druckformat: 1065-5131
ISSN Online: 1563-5074
Indexed in
NUMERICAL SIMULATION OF HEAT TRANSFER PERFORMANCE ENHANCEMENT OF COOLING WATER JACKET USED IN THE CARBON INDUSTRY
ABSTRAKT
In the cooling process of high-temperature calcined petroleum coke (CPC) inside a cooling water jacket, some problems such as uneven heat transfer, difficult heat conduction, and easy oxidation seriously affect the quality of CPC. Based on the computational fluid dynamics, this paper performed heat transfer analysis and numerical simulation for the cooling water jacket on both the water side and coke side, studied the evolutions of the internal temperature field, and obtained the nonuniform temperature field. Meanwhile, in order to enhance the heat transfer performance of the cooling water jacket, one modified measure was put forward by installing heat exchange tubes inside the cooling water jacket. The simulation results manifested that the modified measure of the cooling water jacket can enhance heat transfer performance significantly. Compared with the initial model, the outlet average temperature of CPC reduces by 293.89 K, and the cooling efficiency of the cooling water jacket enhances by 30.84%. Additionally, the temperature uniformity coefficient on the outlet cross section increases by 13.40%, which demonstrates that the modified structure has superior relative heat transfer performance.
-
Cabello, M. and Chyrka, T., Treasure Na-Ion Anode from Trash Coke by Adept Electrolyte Selection, J. Power Sources, vol. 347, pp. 127–135, 2017. DOI: 10.1016/j.jpowsour.2017.02.065
-
Chen, J. and Lu, X., Progress of Petroleum Coke Combusting in Circulating Fluidized Bed Boilers – A Review and Future Perspectives, Resour., Conserv. Recycl., vol. 49, no. 3, pp. 203–216, 2007. DOI: 10.1016/j.resconrec.2006.03.012
-
Chong, X.Y. and Jiang, Y., Mechanical Properties, Electronic Structure and Alkali-Ion Diffusion of Eldfellite-Type AFe(SO<sub>4</sub>)<sub>2</sub> (A = Li, Na, K) as Potential Cathode Materials Comparing with LiFePO<sub>4</sub> J. Micromech. Mol. Phys., vol. 2, no. 1, 498-502, 2017. DOI: 10.1142/S2424913017500023
-
Falter, C.P. and Pitz-Paal, R., Modeling Counter-Flow Particle Heat Exchangers for Two-Step Solar Thermochemical Syngas Production, Appl. Therm. Eng., vol. 135, no. 5, pp. 613–623, 2018. DOI: 10.1016/j.applthermaleng.2017.12.087
-
Hu,W.L. and Wang, L.B., The Effect of Transverse Tube Pitch on the Thermal-Hydrodynamic Performance of a Circular Tube Plate-Fin Heat Exchanger with Fin-Mounted Vortex Generators, J. Enhanced Heat Transf., vol. 22, no. 3, pp. 221–246, 2015. DOI: 10.1615/JEnhHeatTransf.2015014211
-
Hu, Y.Y. and Liu, Z., Origin of Additional Capacities in Metal Oxide Lithium-Ion Battery Electrodes, Nature Mater., vol. 12, no. 12, pp. 1130–1136, 2013. DOI: 10.1038/nmat3784
-
Jayavel, S. and Tiwari, S., Effect of Tube Spacing on Heat Transfer Performance of Staggered Tube Bundles in the Presence of Vortex Generators, J. Enhanced Heat Transf., vol. 17, no. 3, pp. 271–291, 2010. DOI: 10.1615/JEnhHeatTransf.v17.i3.60
-
Jin, X. and Zhong, Q., Modeling the Change of Green Coke to Calcined Coke using Qingdao High-Sulfur Petroleum Coke, Energy and Fuels, vol. 29, no. 5, pp. 3345–3352, 2015. DOI: 10.1021/acs.energyfuels.5b00021
-
Kubota, M. and Ito, T., Pore Structure andWater Adsorptivity of Petroleum Coke-Derived Activated Carbon for Adsorption Heat Pump–Influence of Hydrogen Content of Coke, Appl. Thermal Eng., vol. 31, no. 8, pp. 1495–1498, 2011. DOI: 10.1016/j.applthermaleng.2011.01.036
-
Kukulka, D.J. and Smith, R., Heat Transfer Evaluation of an Enhanced Heat Transfer Tube Bundle, Energy, vol. 72, pp. 97–103, 2014. DOI: 10.1016/j.energy.2014.04.113
-
Leong, J.C. and Jin, K.W., Effect of Sinter Layer Porosity Distribution on Flow and Temperature Fields in a Sinter Cooler, Int. J. Min. Metal. Mater., vol. 16, no. 3, pp. 265–272, 2009. DOI: 10.1016/S1674- 4799(09)60048-0
-
Li, W., Zou, C., and Li, X., Thermo-Physical Properties of Cooling Water-Based Nanofluids Containing TiO<sub>2</sub> Nanoparticles Modified by Ag Elementary Substance for Crystallizer Cooling System, Powder Technol., vol. 329, pp. 434–444, 2018. DOI: 10.1016/j.powtec.2018.01.089
-
Li, X., Zou, C., and Qi, A., Experimental Study on the Thermo-Physical Properties of Car Engine Coolant (Water/Ethylene Glycol Mixture Type) based SiC Nanofluids, Int. Commun. Heat Mass Transf., vol. 77, pp. 159–164, 2016. DOI: 10.1016/j.icheatmasstransfer.2016.08.009
-
Marcios, M.A. and Oliveira, L.S., Modeling and Simulation of Petroleum Coke Calcination in Rotary Kilns, Fuel, vol. 80, no. 11, pp. 1611–1622, 2001. DOI: 10.1016/S0016-2361(01)00032-1
-
Marias, F. and Roustan, H., Modelling of a Rotary Kiln for the Pyrolysis of Aluminum Waste, Chem. Eng. Sci., vol. 60, no. 9, pp. 4609–4622, 2012. DOI: 10.1016/j.ces.2005.03.025
-
Marias, F., A Model of a Rotary Kiln Incinerator Including Processes Occurring within the Solid and the Gaseous Phases, Comp. Chem. Eng., vol. 27, no. 2, pp. 813–825, 2003. DOI: 10.1016/S0098- 1354(02)00268-5
-
Ming, W.X. and Luo, L.J., Optimization of Cooling Water Jacket of the Shaft Kiln based on CFD, Carbon Tech., vol. 32, no. 3, pp. 16–18, 2013. DOI: 10.14078/j.cnki.1001-3741.2013.03.018
-
Muley, A. and Manglik, R.M., A Review on Enhanced Heat Transfer Characteristics of Single-Phase Flows in a Plate Heat Exchangers, J. Enhanced Heat Transf., vol. 24, no. 1, pp. 443–458, 2016. DOI: 10.1615/JEnhHeatTransf.v24.i1-6.320
-
Patisson, F. and Lebas, E., Coal Pyrolysis in a Rotary Kiln: Part II. Overall Model of the Furnace, Metal. Mater. Trans., vol. 31, no. 2, pp. 391–402, 2000a. DOI: 10.1007/s11663-000-0057-4
-
Patisson, F. and Lebas, E., Coal Pyrolysis in a Rotary Kiln: Part I. Model of the Pyrolysis of a Single Grain, Metal. Mater. Trans., vol. 31, no. 2, pp. 381–390, 2000b. DOI: 10.1007/s11663-000-0056-5
-
Sun, J. and Chen, M.M., A Theoretical Analysis of Heat Transfer due to Particle Impact, Int. J. Heat Mass Transf., vol. 31, no. 5, pp. 969–975, 1988. DOI: 10.1016/0017-9310(88)90085-3
-
Thome, J.R., Heat Transfer Augmentation of Shell-and-Tube Heat Exchangers for the Chemical Process Industry, J. Enhanced Heat Transf., vol. 4, no. 2, pp. 147–161, 1997. DOI: 10.1615/JEnhHeat- Transf.v4.i2.70
-
Vargas, W.L. and McCarthy, J.J., Unsteady Heat Conduction in Granular Materials, AIChE J., vol. 47, no. 5, pp. 1052–1059, 2001. DOI: 10.1002 / aic.690470511
-
Wang, J. and Anthony, E.J., Clean and Efficient Use of Petroleum Coke for Combustion and Power Generation, Fuel, vol. 83, no. 10, pp. 1341–1348, 2004. DOI: 10.1016/j.fuel.2004.01.002
-
Xiao, J. and Yu, B., Superheated Water Pretreatment Combined with CO<sub>2</sub> Activation/Regeneration of the Exhausted Activated Carbon Used in the Treatment of Industrial Wastewater, Water Sci. Technol., vol. 76, no. 7, pp. 1687–1696, 2017. DOI: 10.2166/wst.2017.285
-
Xiao, J. and Zhang, Y., Reduction and Desulfurization of Petroleum Coke in Ammonia and Their Thermodynamics, Energy Fuels, vol. 30, no. 4, pp. 3385–3391, 2016. DOI: 10.1021/acs.energyfuels.5b02929
-
Xu, Z.M. and Zhang, Z.B., Experimental Investigation of the Applied Performance of Several Typical Enhanced Tubes, J. Enhanced Heat Transf., vol. 17, no. 4, pp. 331–341, 2010. DOI: 10.1615/JEnhHeat- Transf.v17.i4.40
-
Yagi, S. and Kunii, D., Studies on Axial Effective Thermal Conductivities in Packed Beds, AIChE J., vol. 3, no. 3, pp. 373–381, 1957. DOI: 10.1002/aic.690030317
-
Zhang, J. and Wang, G., Energy Saving Technologies and Productive Efficiency in the Chinese Iron and Steel Sector, Energy, vol. 33, no. 4, pp. 525–537, 2008. DOI: 10.1016/j.energy.2007.11.002
-
Zhang, X. and Xu, L., Study on Local Heat Exchanger Factor and Inverse Problem of Heat Conduction in Coke, Fuel Chem. Proc., vol. 35, no. 6, pp. 8–11, 2004. DOI: 10.16044/j.cnki.rlyhg.2004.06.003
-
Zhang, Z. and Yang, W., Numerical Simulation on Enhanced Heat Transfer of Heat-Exchange Tube with Assembled Rotors, Comp. Aided Eng., vol. 20, no. 2, pp. 57–62, 2011.
-
Zheng, B. and Liu, Y., Study on Thermo-Physical Properties of Calcined Petroleum Coke, Light Metals, vol. 3, no. 32, pp. 43–44, 2000. DOI: 10.14078/j.cnki.1001-3741.2013.03.012
-
Zhong, Q. and Xiao, J., Thiophenic Sulfur Transformation in a Carbon Anode during the Aluminum Electrolysis Process, Energy Fuels, vol. 31, no. 4, pp. 4539–4547, 2017. DOI: 10.1021/acs.energyfuels.6b03018
-
Zimparov, V.D. and Vulchanov, N.L., Performance Evaluation Criteria for Enhanced Heat Transfer Surfaces, Int. J. Heat Mass Transf., vol. 37, no. 12, pp. 1807–1816, 1994. DOI: 10.1016/0017- 9310(94)90069-8
-
Guo Yun, Zhang Xuning, Zhou Zhongwei, Coupled Heat and Flow Analysis Inside a Diversion-Type Gas Heater With Vertical Guide Plate Structure, Frontiers in Energy Research, 10, 2022. Crossref