Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
SJR: 0.19 SNIP: 0.341 CiteScore™: 0.43

ISSN Druckformat: 1093-3611
ISSN Online: 1940-4360

High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes

DOI: 10.1615/HighTempMatProc.v8.i3.20
pages 339-351

CORRECTION FOR CALCULATION OF PARTICLE HEAT TRANSFER IN THERMAL PLASMAS

Sergey V. Dresvin
Laboratory of Electrotechnological and Plasma Installation of Polytechnic Institute -SPb State Polytechnical University, 29 Polytechnicheskaya Str., 195251 Saint-Petersburg, Russia
Jacques Amouroux
Laboratoire de Genie des Precedes Plasmas Universite P. et M. Curie, ENSCP 11 rue P. et M. Curie 75005 Paris France
S. G. Zverev
St. Petersburg State Polytechnic University, 29 Politekhnicheskaya Str., St. Petersburg, 195251, Russia
D. Ivanov
St. Petersburg State Polytechnic University, 29 Politekhnicheskaya Str., St. Petersburg, 195251, Russia

ABSTRAKT

One of the most widespread areas of plasma technology is a treatment of fine-dispersed materials in plasma jets. Complexity of an experimental research of system "plasma flow - particles" has caused the creation of the mathematical models describing movement, heat transfer and physical and chemical transformations of dispersed materials in plasma. Researches of heat transfer in high-temperature flows are of significant interest as heat transfer from plasma to particles of powder is the determining factor.
A number of studies of particle heat transfer in thermal plasmas give the following expression for Nusselt number: Nu=2+A·Re0.5·Pr0.33, where A is constant. However, this expression overestimates Nu in comparison with experimental data. In this connection authors offer the criterial expression for calculation of particle heat transfer in plasma taking into account the correction for conductive term: Nu=2·(Vs/Vp)+A·Re0.5·Pr0.33. Introduction of correction namely Vs/Vp obviously explains mechanism of influence of heat transfer conductive component on particle conductive-convective heat transfer in thermal plasma and result in sufficiently good agreement of calculations with numerous experimental data.


Articles with similar content:

Correction for Calculation of Particle Heat Transfer in Thermal Plasma
Heat Transfer Research, Vol.39, 2008, issue 3
D. Ivanov, Sergey V. Dresvin, S. G. Zverev
EXPERIMENTAL INVESTIGATION OF THE EFFECT EXERTED BY NANOPARTICLES ON THE HEAT TRANSFER COEFFICIENT OF HERSCHEL−BULKLEY FLUIDS
Heat Transfer Research, Vol.45, 2014, issue 6
Saeed Zeinali Heris, Roozbeh Mollabbasi, Seyyed Hosein Noie
CONVECTIVE EVAPORATION OF A SPHERICAL SUPER-REFRACTORY PARTICLE INSIDE A THERMAL PLASMA : THE STOKES' PROBLEM IN A FLUID WITH VARIABLE PROPERTIES
International Heat Transfer Conference 5, Vol.7, 1974, issue
P. Dumargue, C. Bonet, M. Daguenet
NUMERICAL ANALYSIS OF MOMENTUM, HEAT AND MASS TRANSFER BETWEEN NITROGEN PLASMA AND INJECTED Al PARTICLES IN AXISYMMETRIC REACTOR
Progress in Plasma Processing of Materials, 1997, Vol.1, 1997, issue
Zivota G. Kostic, Pavle B. Pavlovic, Dejan B. Cvetinovic, Predrag Lj. Stefanovic
A synthetic and Consistent Approach in Modelling Plasma Physics, Plasma Chemistry and Surface Interactions
Progress in Plasma Processing of Materials, 1997, Vol.1, 1997, issue
Evangelos Gogolides