Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
TsAGI Science Journal

ISSN Druckformat: 1948-2590
ISSN Online: 1948-2604

TsAGI Science Journal

DOI: 10.1615/TsAGISciJ.2015013357
pages 803-824

METHOD OF MANUFACTURING ACCURACY EVALUATION OF WIND TUNNEL MODELS BY MEASURING DATA FROM A COORDINATE-MEASURING MACHINE

M. A. Arkhangelskaya
Central Aerohydrodynamic Institute (TsAGI), 1 Zhukovsky St., Zhukovsky, Moscow Region, 140180, Russia
Vladimir Dmitrievich Vermel
Central Aerohydrodynamic Institute (TsAGI) Zhukovsky str. 1, Zhukovsky, 140180 Russia
V. F. Zabaluev
Central Aerohydrodynamic Institute (TsAGI), 1 Zhukovsky St., Zhukovsky, Moscow Region, 140180, Russia
P. M. Nikolaev
Central Aerohydrodynamic Institute (TsAGI), 1 Zhukovsky St., Zhukovsky, Moscow Region, 140180, Russia
Leonid Leonidovich Chernyshev
Central Aerohydrodynamic Institute (TsAGI), 1 Zhukovsky St., Zhukovsky, Moscow Region, 140180, Russia

ABSTRAKT

The main geometric features of wind tunnel models and their units, such as the accuracy of the model's location in the wind tunnel's test section, accuracy of the model's assembly, deviations from specified aerodynamic twists and V-shaped wings, reproduction of the outlines of the main surface profiles, etc., are evaluated by the model's surface points by measuring the data using a coordinatemeasuring machine (CMM). Unlike traditional evaluations commonly found in engineering, in which the accuracy of a part is found through measuring point deviations from the part's surface, the separation of errors by components in the model's geometric features required to form the special processing procedure based on a search of the geometric correspondence between the measuring points and points of mathematical model and matching them by using a least-squares method. A way to increase the convergence of the measuring data matching procedure to the mathematical model is proposed for weakly curved surfaces. An example of evaluating manufacturing accuracy of a largesize wind tunnel half-model of an airliner is presented.


Articles with similar content:

DESIGN PARAMETERS AFFECTING THE ACCURACY OF ISOTHERMAL THERMOCOUPLES
International Heat Transfer Conference 5, Vol.10, 1974, issue
Phillip Joseph Legendre
A Combined Algorithm of the In-Flight Geometric Calibration Using Unknown Landmarks
Journal of Automation and Information Sciences, Vol.51, 2019, issue 1
Alexander I. Tkachenko
ALGORITHMS FOR STRUCTURAL TOPOLOGY OPTIMIZATION
TsAGI Science Journal, Vol.42, 2011, issue 2
V. V. Sysoeva, Vasilii Vasil'evich Chedrik
On an Approach to Identification of Dynamic Systems Under Uncertainty
Journal of Automation and Information Sciences, Vol.32, 2000, issue 3
Vyacheslav F. Gubarev, Nikolay N. Aksenov
Measurements of Low-Flying Target Altitudes in Standard Three-Dimensional Surveillance VHF-Band Radars
Telecommunications and Radio Engineering, Vol.57, 2002, issue 10-11
A.A. Malyshev