Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
International Journal for Multiscale Computational Engineering
Impact-faktor: 1.016 5-jähriger Impact-Faktor: 1.194 SJR: 0.452 SNIP: 0.68 CiteScore™: 1.18

ISSN Druckformat: 1543-1649
ISSN Online: 1940-4352

International Journal for Multiscale Computational Engineering

DOI: 10.1615/IntJMultCompEng.2016018635
pages 555-584

GRAPHENE/CARBON NANOTUBE REINFORCED METALLIC GLASS COMPOSITES: A MOLECULAR DYNAMICS STUDY

Sumit Sharma
B.R. Ambedkar National Institute of Technology, Jalandhar, India
Pramod Kumar
Department of Mechanical Engineering, Dr. B. R. Ambedkar National Institute of Technology, Jalandhar, India
Rakesh Chandra
Department of Mechanical Engineering, Dr. B. R. Ambedkar National Institute of Technology, Jalandhar, India

ABSTRAKT

Single-layer graphene sheets and carbon nanotubes (CNTs) have resulted in the development of new materials for a variety of applications. Though there are a large number of experimental and numerical studies related to these nanofillers, still there is a lack of understanding of the effect of geometrical characteristics of these nanofillers on their mechanical properties. In this study, molecular dynamics (MD) simulation has been used to study the effect of CNT and graphene reinforcements on the mechanical properties of amorphous metallic glass (MG). Materials Studio 7.0 has been used as a tool for finding the tensile modulus, yield strength, and yield strain of anocomposites. Both short and long CNT and graphene reinforced MG composites have been studied. The effect of nanofiller volume fraction (Vf) on the mechanical properties has also been studied. Results showed that with increase in Vf the Young's modulus of long graphene/MG composites increased at a faster rate than that for long CNT/MG composites. For the same Vf, the Young's modulus of long graphene/MG composite was higher than long CNT/MG composite, thus showing that graphene is a better reinforcement than CNT for MG based composites. MG with short nanoreinforcements showed very small improvement in mechanical properties.


Articles with similar content:

GRAPHENE/CARBON NANOTUBE-REINFORCED NICKEL COMPOSITES: A MOLECULAR DYNAMICS STUDY
Composites: Mechanics, Computations, Applications: An International Journal, Vol.9, 2018, issue 3
Sumit Sharma, Navin Kumar, Pramod Kumar, Rakesh Chandra
Atomistic Understanding of the Particle Clustering and Particle Size Effect on the Room Temperature Strength of SiC-Si3N4 Nanocomposites
International Journal for Multiscale Computational Engineering, Vol.8, 2010, issue 5
Han Sung Kim, Vikas Samvedi, Vikas Tomar
BENCHTOP MICROREACTOR BUILT FOR DIAGNOSTIC DEPOSITION OF CU3BIS3 FOR USE IN PHOTOVOLTAIC DEVICES
Computational Thermal Sciences: An International Journal, Vol.7, 2015, issue 5-6
Jerry W. Shan, Dunbar P. Birnie, III, Joshua A. Epstein, Richard J. Castellano
TRIBOMECHANICAL PERFORMANCE OF GLASS–EPOXY HYBRID COMPOSITES FILLED WITH MARBLE POWDER WITH THE TAGUCHI DESIGN AND ARTIFICIAL NEURAL NETWORK
Composites: Mechanics, Computations, Applications: An International Journal, Vol.10, 2019, issue 1
Arun Kumar Rout, Subhrajit Ray, Ashok Kumar Sahoo
CARBON NANOTUBE REINFORCED POLYETHYLENE COMPOSITES: A MOLECULAR DYNAMICS APPROACH
International Journal for Multiscale Computational Engineering, Vol.14, 2016, issue 2
Sumit Sharma, Rahul Anjana