Abo Bibliothek: Guest
Digitales Portal Digitale Bibliothek eBooks Zeitschriften Referenzen und Berichte Forschungssammlungen
Atomization and Sprays
Impact-faktor: 1.262 5-jähriger Impact-Faktor: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Druckformat: 1044-5110
ISSN Online: 1936-2684

Volumes:
Volumen 29, 2019 Volumen 28, 2018 Volumen 27, 2017 Volumen 26, 2016 Volumen 25, 2015 Volumen 24, 2014 Volumen 23, 2013 Volumen 22, 2012 Volumen 21, 2011 Volumen 20, 2010 Volumen 19, 2009 Volumen 18, 2008 Volumen 17, 2007 Volumen 16, 2006 Volumen 15, 2005 Volumen 14, 2004 Volumen 13, 2003 Volumen 12, 2002 Volumen 11, 2001 Volumen 10, 2000 Volumen 9, 1999 Volumen 8, 1998 Volumen 7, 1997 Volumen 6, 1996 Volumen 5, 1995 Volumen 4, 1994 Volumen 3, 1993 Volumen 2, 1992 Volumen 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2014009901
pages 599-623

EXPERIMENTAL STUDY ON FLOW FIELDS OF FUEL DROPLETS AND AMBIENT GAS OF DIESEL SPRAY-FREE SPRAY AND FLAT-WALL IMPINGING SPRAY

Jingyu Zhu
Mazda Motor Corporation, 3-1 Shinchi, Fuchu-cho, Aki-gun, Hiroshima 730-8670, Japan
Keiya Nishida
Department of Mechanical System Engineering, University of Hiroshima, 1-4-1 Kagamiyama, Higashi-Hiroshima, Hiroshima 739-8527, Japan
Takumi Uemura
Department of Mechanical System Engineering, Hiroshima University, 1-4-1 Kagamiyama, Higashi Hiroshima 739-8527, Japan

ABSTRAKT

The ambient gas flow fields of the free spray and flat wall-impinging spray were measured by using laser induced fluorescence-particle image velocimetry (LIF-PIV) technique in non-evaporating condition. The ambient gas velocity distribution and gas mass flow rate into the spray were analyzed. The droplet flow velocity and vorticity of free spray and impinging spray were measured by particle image velocimetry (PIV) technique, the correlation of spray droplet flow and ambient gas flow under the free spray and impinging spray conditions was studied. The effects of impinging distances (30 mm, 40 mm) and injection pressures (100 MPa, 200 MPa, 300 MPa) were taken into account. Comparing with the free spray, the impinging spray restricts the ambient gas flow at the specific timing; however, showing the same or higher ambient gas flow as function of the penetrating length. Furthermore, the increased vorticity intensity implies that the turbulent mixing and mixture formation inside the spray tend to be improved. The increased fuel injection pressure effectively improves the ambient gas flow and the vorticity intensity of the spray. The effect of injection pressure on the improvement of ambient gas flow becomes moderate under the impingement condition. The shorter spray−wall impinging distance restricts the increase of the spray volume and the ambient gas mass flow rate.


Articles with similar content:

QUANTITATIVE ANALYSES OF FUEL SPRAY-AMBIENT GAS INTERACTION BY MEANS OF LIF-PIV TECHNIQUE
Atomization and Sprays, Vol.21, 2011, issue 6
Olawole Abiola Kuti, Keiya Nishida, Jingyu Zhu, Seoksu Moon
CHARACTERISTICS OF SPRAYS THROUGH A WALL IMPINGEMENT INJECTOR
Atomization and Sprays, Vol.14, 2004, issue 4
Takao Inamura, Terutoshi Tomoda
CHARACTERIZATION OF EVAPORATING DIESEL SPRAYS USING EXCIPLEX LASER-INDUCED FLUORESCENCE MEASUREMENTS
Atomization and Sprays, Vol.13, 2003, issue 5&6
J. B. Ghandhi, T. Kim
EXPERIMENTAL STUDY ON VELOCITY DISTRIBUTION OF POST-IMPINGEMENT DIESEL SPRAY ON A WALL. PART 2: EFFECT OF AMBIENT GAS DENSITY AND INJECTION PRESSURE ON FLOW PATTERN
Atomization and Sprays, Vol.26, 2016, issue 9
Yotsugu Odawara, Yoshio Zama, Tomohiko Furuhata
DIESEL SPRAY IMPINGING ON A FLAT WALL. PART II: VOLUME AND AVERAGE AIR-FUEL RATIO OF AN IMPINGEMENT DIESEL SPRAY
Atomization and Sprays, Vol.12, 2002, issue 5&6
Masataka Arai, Kyungnam Ko