Library Subscription: Guest
Begell Digital Portal Begell Digital Library eBooks Journals References & Proceedings Research Collections
Journal of Enhanced Heat Transfer
IF: 1.406 5-Year IF: 1.075 SJR: 0.287 SNIP: 0.653 CiteScore™: 1.2

ISSN Print: 1065-5131
ISSN Online: 1563-5074

Journal of Enhanced Heat Transfer

DOI: 10.1615/JEnhHeatTransf.v9.i2.20
pages 69-76

Forced Convective Boiling of a Flurocarbon Liquid in Reduced Size Channels – an Experimental Study

Hitoshi Miznuma
Toshiba Electronics, Taiwan
Masud Behnia
School of Mechanical and Manufacturing Engineering, University of New South Wales, Sydney 2052, Australia
Wataru Nakayama
Tokyo Institute of Technology, 2-12-1 Oh-Okayama, Meguro-ku Tokyo 152, Japan

ABSTRACT

The present paper reports the results of an experimental study of forced convection boiling heat transfer from a 2 cm × 2 cm simulated chip to a fluorocarbon coolant (FX-3250) in a parallel-plate channel. The experimental parameters were the channel height (1 and 5 mm), the surface geometry of the simulated chip (flat and microfilmed), and the coolant velocity (0.125−4 m/s). Longitudinal microfins (0.5 mm high x 0.5 mm wide) on the finned chip increased the actual surface area to about twice that of the flat surface.
Attention was focused on the data of the 1-mm high channel. When compared with the flat chip data on the footprint area basis, the microfins produced 40% of heat transfer enhancement at coolant velocities less than 1 m/s; however, the enhancement diminishes at higher velocities. The boiling curves of the finned chip, based on the actual area, seem to reflect that there is an effect due to the bypassing of flow through the cross-section over the fins. For both the flat chip and the finned chip there are crisis points where the two-phase flow becomes unstable at low coolant velocities. The practice of degassing produced negligible effects on boiling heat transfer in the 1-mm high channel.


Articles with similar content:

FLOW BOILING CRITICAL HEAT FLUXES FOR WATER IN A VERTICAL ANNULUS AT LOW PRESSURE AND VELOCITIES
International Heat Transfer Conference 7, Vol.9, 1982, issue
J. T. Rogers, A. E. E. Tahir, Martha Eva Salcudean
THE INFLUENCE OF SUBCOOLING ON THE POOL NUCLEATE BOILING AND CRITICAL HEAT FLUX OF SIMULATED ELECTRONIC CHIPS
International Heat Transfer Conference 9, Vol.2, 1990, issue
Arthur E. Bergles, R. D. M. Carvalho
CONDENSATION OF ATMOSPHERIC PRESSURE STEAM ON INTEGRAL-FIN TUBES - EFFECT OF FIN HEIGHT AND VAPOUR VELOCITY
International Heat Transfer Conference 13, Vol.0, 2006, issue
S. Namasivayam
SIZE DISTRIBUTIONS OF ACTIVE NUCLEATION SITES WITH POOL BOILING HEAT TRANSFER AT SINGLE TUBES WITH DIFFERENT ROUGHNESSES
International Heat Transfer Conference 10, Vol.12, 1994, issue
Heiko Schomann, Dieter Gorenflo, Andrea Luke
THE EFFECTS OF NON-UNIFORM HEAT TRANSFER COEFFICIENTS IN THE DESIGN OF FINNED TUBE AIR-COOLED HEAT EXCHANGERS
International Heat Transfer Conference 7, Vol.15, 1982, issue
Peter J. Heggs, P. R. Stones