Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.28 SNIP: 0.421 CiteScore™: 0.9

ISSN Imprimir: 2150-766X
ISSN En Línea: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.2012005014
pages 297-319

PARTICLE COMBUSTION DYNAMICS OF METAL-BASED REACTIVE MATERIALS

Edward L. Dreizin
New Jersey Institute of Technology, Newark, New Jersey 07102, USA; Tomsk State University, Tomsk, 634050, Russia
Carlo Badiola
New Jersey Institute of Technology, Newark, NJ, USA
Shasha Zhang
New Jersey Institute of Technology, Newark, NJ 07029 USA; Key Laboratory of Hydraulic Machinery Transients, MOE, Wuhan University, Wuhan, 430072, China; School of Power and Mechanical Engineering, Wuhan University, Wuhan, Hubei 430072, China
Yasmine Aly
New Jersey Institute of Technology, Newark, New Jersey, USA

SINOPSIS

Micron-sized particles of aluminum and aluminum-based reactive materials were fed into a CO2 laser beam where they were ignited. Just prior to entering the CO2 beam, particles were illuminated by a low-power infrared laser, and their sizes were measured in situ using the intensity of scattered light. Experiments are presented for spherical Al and nanocomposite powders prepared by mechanical milling, including Al·CuO, Al·MoO3, Al·I2, Al·B·I2, Al-wax, and Al-polyethylene. The particle emission signals were recorded and their combustion temperatures were measured optically. In addition, the intensity of molecular AlO emission was monitored. Experiments were performed in air for all materials; additional data for Al combustion in different oxidizers are also presented. For all materials, the effect of particle size on its burn time was observed to be small. No composite material demonstrated consistently higher temperatures or shorter burn times compared to Al powders. For materials with volatile additives (I2, wax, polyethylene), particle combustion was accompanied by pronounced oscillatory patterns; especially large vapor-phase flames were observed for Al−hydrocarbon composites. Distinct surface reactions were observed for Al·B·I2 composite particles, which also had the longest burn times compared to other materials. Al·CuO particles fragmented upon ignition while Al·MoO3 particles burned relatively slowly and without fragmentation.


Articles with similar content:

PREPARATION AND CHARACTERIZATION OF GRANULAR HYBRID REACTIVE MATERIALS
International Journal of Energetic Materials and Chemical Propulsion, Vol.9, 2010, issue 3
Yasmine Aly, Alexandre Ermoline, Mikhaylo A. Trunov, Mirko Schoenitz, Edward L. Dreizin
ON GAS RELEASE BY THERMALLY-INITIATED FULLY-DENSE 2Al·3CuO NANOCOMPOSITE POWDER
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 3
Alexandre Ermoline, Mirko Schoenitz, Edward L. Dreizin, Rayon A. Williams
FUEL-RICH ALUMINUM−METAL FLUORIDE THERMITES
International Journal of Energetic Materials and Chemical Propulsion, Vol.16, 2017, issue 1
Mirko Schoenitz, Siva Kumar Valluri, Edward L. Dreizin, Ian Monk
SYNTHESIS AND CHARACTERIZATION OF COATED ENERGETIC MATERIALS USING A RESS-N SYSTEM
International Journal of Energetic Materials and Chemical Propulsion, Vol.9, 2010, issue 2
Jonathan T. Essel, Kenneth K. Kuo, Andrew C. Cortopassi
OXIDATION, IGNITION AND COMBUSTION OF AL-HYDROCARBON COMPOSITE REACTIVE POWDERS
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 4
Shasha Zhang, Mirko Schoenitz, Edward L. Dreizin