Heat Transfer Research
Publicado 18 números por año
ISSN Imprimir: 1064-2285
ISSN En Línea: 2162-6561
IF:
1.7
5-Year IF:
1.4
Immediacy Index:
0.6
Eigenfactor:
0.00072
JCI:
0.43
SJR:
0.318
SNIP:
0.568
CiteScore™::
3.5
H-Index:
28
Indexed in
Volumen 30, 1999 Edición 4-6
DOI: 10.1615/HeatTransRes.v30.i4-6
Optimization Principles of Mass Transfer Technologies Based on Discrete-Pulse Energy Inputs
pp. 213-219
DOI: 10.1615/HeatTransRes.v30.i4-6.10
Heat Transfer at Axisymmetric and Flat Surfaces with Protective Screens
pp. 220-230
DOI: 10.1615/HeatTransRes.v30.i4-6.20
Effect of Centrifugal Instability on Boundary Layer Heat Transfer at a Concave Surface
pp. 231-237
DOI: 10.1615/HeatTransRes.v30.i4-6.30
Integral Method of Calculation of a Turbulent Centrifugal Underswirl Flow in a Gap between Parallel Rotating
pp. 238-248
DOI: 10.1615/HeatTransRes.v30.i4-6.40
Approximate Calculation of Heat and Mass Transfer in a Jet Flowing into a Fluidized Layer
pp. 249-256
DOI: 10.1615/HeatTransRes.v30.i4-6.50
Heat Transfer for a Distributed Injection of Foreign Matter with the Formation of an Interface
pp. 257-265
DOI: 10.1615/HeatTransRes.v30.i4-6.60
Basic Concepts of the Evaluation and the Development of Geothermal Resources
pp. 266-274
DOI: 10.1615/HeatTransRes.v30.i4-6.70
New Technological Cavitation-Induced Effects of Heat and Mass Transfer
pp. 275-288
DOI: 10.1615/HeatTransRes.v30.i4-6.80
Minimization of Thermal Stresses in Continuously-Cast Ingot with Restriction on its Molten-Metal Pool Volume
pp. 296-302
DOI: 10.1615/HeatTransRes.v30.i4-6.100
Improvement of Thermal Protection Systems for Rotors of Industrial Gas-Turbine Plants
pp. 311-323
DOI: 10.1615/HeatTransRes.v30.i4-6.120
Development and Introduction of Effective Waste-Heat Recovery Units Based on Heat-Transfer Elements of the Evaporation-Condensation Type
pp. 324-329
DOI: 10.1615/HeatTransRes.v30.i4-6.130
Methods of a Decrease of the Expenditure of Energy for Cooling High-Temperature Gas-Turbine Plants
pp. 330-336
DOI: 10.1615/HeatTransRes.v30.i4-6.140
Small Energetics: State of Development and Prospects in the Institute of Engineering Thermophysics, National Academy of Sciences of Ukraine
pp. 337-345
DOI: 10.1615/HeatTransRes.v30.i4-6.150
On the Payback of the Costs for the Construction of Cogeneration Plants for District Heating
pp. 346-356
DOI: 10.1615/HeatTransRes.v30.i4-6.160
Devices for the Automatic Control of Incomplete Burning of Gas, Liquid, and Solid Fuel in Industrial Thermal Units
pp. 357-369
DOI: 10.1615/HeatTransRes.v30.i4-6.170
The Use of Fluidized-Bed Technologies for the Reconstruction of Small Coal-Fired Boiler Unitst
pp. 370-374
DOI: 10.1615/HeatTransRes.v30.i4-6.180
Thermal and Aerodynamic Characteristics of Tlibe Banks with Spiral-Welded Ribbon Fins
pp. 375-384
DOI: 10.1615/HeatTransRes.v30.i4-6.190
Dynamics of Semi-Infinite and Local Sites of Film Boiling
pp. 400-410
DOI: 10.1615/HeatTransRes.v30.i4-6.210
Upward Two-Phase Flow in a Vertical Annular Channel (Effect of Spacer Geometry)
pp. 411-421
DOI: 10.1615/HeatTransRes.v30.i4-6.220
Último edicion
PREPARATION METHOD AND THERMAL PERFORMANCE OF A NEW ULTRA-THIN FLEXIBLE FLAT PLATE HEAT PIPE
ANALYZING THE HEAT AND FLOW CHARACTERISTICS IN SPRAY COOLING BY USING AN OPTIMIZED RECTANGULAR FINNED HEAT SINK
FLOW BOILING HEAT TRANSFER COEFFICIENT USED FOR THE DESIGN OF THE EVAPORATOR OF A REFRIGERATION MACHINE USING CO2 AS WORKING FLUID
Próximos Artículos
Analysis of Thermal Performance in a Two-phase Thermosyphon loop based on Flow Visualization and an Image Processing Technique
Investigation of the Effect of Dead State Temperature on the Performance of Boron Added Fuels and Different Fuels Used in an Internal Combustion Engine.
PREDICTION OF PARAMETERS OF BOILER SUPERHEATER BASED ON TRANSFER LEARNING METHOD
A temperature pre-rectifier with continuous heat storage and release for waste heat recovery from periodic flue gas
Study on the Influence of Multi-Frequency Noise on the Combustion Characteristics of Pool Fires in Ship Engine Rooms
Experimental study on two-phase nonlinear oscillation behavior of miniaturized gravitational heat pipe
Flow boiling heat transfer Coefficient used for the Design of the Evaporator of a Refrigeration Machine using CO2 as Working Fluid
Analyzing The Heat and Flow Characteristics In Spray Cooling By Using An Optimized Rectangular Finned Heat Sink
Thermal management of lithium-ion battery packs by using corrugated channels with nano-enhanced cooling
Convective heat transfer inside a rotating helical pipe filled with saturated porous media
Preparation method and thermal performance of a new ultra-thin flexible flat plate heat pipe
Influence of Temperature Gradients and Fluid Vibrations on the Thermocapillary Droplet Behavior in a Rotating Cylinder
The Effect of Corrugation on Heat Transfer and Pressure Drop in a Solar Air Heater: A Numerical Investigation
Investigation of the Effect of Using Different Nanofluids on the Performance of the Organic Rankine Cycle
Entropy generation and heat transfer performance of cylindrical tube heat exchanger with perforated conical rings: a numerical study
Molecular dynamics study of the thermal transport properties in the graphene/C3N multilayer in-plane heterostructures
Flow boiling critical heat flux in a small tube for FC-72
STUDY OF FORCED ACOUSTIC OSCILLATIONS INFLUENCE ON METHANE OXIDATION PROCESS IN OXYGEN-CONTAINING FLOW OF HYDROGEN COMBUSTION PRODUCTS
Examining the Synergistic Use of East-West Reflector and Coal Cinder in Trapezoidal Solar Pond through Energy Analysis