Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
Heat Transfer Research
Factor de Impacto: 0.404 Factor de Impacto de 5 años: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN Imprimir: 1064-2285
ISSN En Línea: 2162-6561

Volumes:
Volumen 50, 2019 Volumen 49, 2018 Volumen 48, 2017 Volumen 47, 2016 Volumen 46, 2015 Volumen 45, 2014 Volumen 44, 2013 Volumen 43, 2012 Volumen 42, 2011 Volumen 41, 2010 Volumen 40, 2009 Volumen 39, 2008 Volumen 38, 2007 Volumen 37, 2006 Volumen 36, 2005 Volumen 35, 2004 Volumen 34, 2003 Volumen 33, 2002 Volumen 32, 2001 Volumen 31, 2000 Volumen 30, 1999 Volumen 29, 1998 Volumen 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.2018021867
pages 881-898

EMISSIVITY MODEL OF ALUMINUM 6063 WITH AN OXIDE FILM AT A WAVELENGTH OF 1.5 μm IN THE TEMPERATURE RANGE 800–910 K

Wei Xing
College of Physics and Material Science, Henan Normal University, Xinxiang 453007, China
Deheng Shi
College of Physics and Material Science, Henan Normal University, Xinxiang 453007, China
Zunlue Zhu
College of Physics and Material Science, Henan Normal University, Xinxiang 453007, China
Jinfeng Sun
College of Physics and Material Science, Henan Normal University, Xinxiang 453007, China

SINOPSIS

This paper models the variation of emissivity with temperature or/and surface oxidation. The emissivity measurements were done at a wavelength of 1.5 μm over the temperature range from 800 to 910 K. The sample was heated to a certain temperature in air and kept at that temperature for approximately 6 h during the experiment. The radiation was received by an InGaAs detector. The surface temperature of samples was measured by two thermocouples, which were symmetrically welded on the surface of the samples. The average of their readings was regarded as the true temperature. Eleven models were used to investigate the variation of emissivity with growth of an oxide layer on the sample surface at a certain temperature. The effect of the number of parameters used in the models on the fitting quality was evaluated. The fitting quality of the emissivity models with the same number of parameters was compared. The variation of emissivity with temperature was studied at a certain thickness of the oxide film. Three approximate models were used to explore the variation in emissivity with temperature and thickness of the oxide layer, with two of them being found to accurately reproduce the emissivity. The strong oscillations of emissivity were observed during the initial heating period, which were affirmed to arise from the interference effect between the two radiations stemming from the oxide film and coming from the substrate.


Articles with similar content:

MODELING THE NORMAL SPECTRAL EMISSIVITY OF BRASS H62 AT 800–1100 K DURING OXIDE LAYER GROWTH
Heat Transfer Research, Vol.49, 2018, issue 15
Deheng Shi, Jinfeng Sun, Zunlue Zhu, Fenghui Zou
EXPERIMENTAL DETERMINATION OF EMISSIVITY MODELS OF STEEL 201 AT 800−1100 K DURING OXIDE LAYER GROWTH
Heat Transfer Research, Vol.49, 2018, issue 14
Deheng Shi, Jinfeng Sun, Zunlue Zhu, Wenjie Zhu
EMISSIVITY MODEL OF STEEL 316L AT 800–1100 K DURING OXIDE LAYER GROWTH ON THE SPECIMEN SURFACE
Heat Transfer Research, Vol.50, 2019, issue 7
Deheng Shi, Shan Sun, Jinfeng Sun, Zunlue Zhu
Heat Transport Along Polar Nanofilms Due to Surface Phonon-Polaritons
International Heat Transfer Conference 15, Vol.55, 2014, issue
Thomas Antoni, Beomjoon Kim, Sebastian Volz, Yann Chalopin, Laurent Tranchant, Jose Ordonez-Miranda
Water Boiling on Highly Superheated Hemispherical Samples
International Heat Transfer Conference 12, Vol.38, 2002, issue
Yuri Albertovich Zeigarnik, Vyacheslav G. Zhilin, Yurii P. Ivochkin, Vladimir R. Tsoi, Oleg A. Sinkevich, Vasilii V. Glazkov