Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
Journal of Flow Visualization and Image Processing
SJR: 0.161 SNIP: 0.312 CiteScore™: 0.1

ISSN Imprimir: 1065-3090
ISSN En Línea: 1940-4336

Journal of Flow Visualization and Image Processing

DOI: 10.1615/JFlowVisImageProc.v13.i3.40
pages 265-286

EXPERIMENTAL INVESTIGATIONS ON FLUIDIC CONTROL OVER AN AIRFOIL

S. Bourgois
Laboratoire d'Etudes Aérodynamiques, Ecole Nationale Supérieure de Mécanique et d'Aérotechnique, Téléport 2, 1 Avenue Clement Ader B. P. 40109, 86961 Futuroscope Chasseneuil CEDEX, France
Jean Tensi
Laboratoire d'Etudes Aérodynamiques, Ecole Nationale Supérieure de Mécanique et d'Aérotechnique, Téléport 2, 1 Avenue Clement Ader B. P. 40109, 86961 Futuroscope Chasseneuil CEDEX, France
E. Sommier
Laboratoire d'Etudes Aérodynamiques, Ecole Nationale Supérieure de Mécanique et d'Aérotechnique, Téléport 2, 1 Avenue Clement Ader B. P. 40109, 86961 Futuroscope Chasseneuil CEDEX, France
J. Favier
Institut de Mécanique des Fluides de Toulouse, Allee du Professeur Camille Soula, 31400 Toulouse, France

SINOPSIS

This study presents the development of two fluidic actuators − namely, microjets and tangential blowing actuator (TBA), designed for flow separation control. The developed actuators are compact enough to fit inside an ONERA D profiled wing with a chord of 0.35 m. Test bench experiments showed that the microjets (resp. TBA) were able to produce exit velocities up to 330 m/s (resp. 60 m/s). These actuators were placed in the model and were tested in wind tunnels for various blowing rates. The investigations included the use of force balance measurements, on-surface flow visualization with pigmented oil, off-surface flow visualizations with smoke, surface pressure distribution measurements, and Particle Image Velocimetry (PIV). Most of the tests were performed at free-stream velocities between 20 m/s (for PIV) and 40 m/s, corresponding to Reynolds numbers in the range 0.47 × 106−0.93 × 106 . The angle of attack varied from −2 to 20 degrees. Experiments were conducted using the naturally occurring laminar boundary layer as well as for a turbulent boundary layer. In such a case, rough strips were used in the vicinity of the leading edge. The present tests show the efficiency of these devices to delay separation and improve aerodynamic performances of the wing: for example, a maximum of 30% gain in CL has been reached using the microjets. Both actuators tend to increase the lift coefficient CL after stall and areas of separated flow have been eliminated by applying control, as suggested by flow visualizations and PIV velocity fields.


Articles with similar content:

EXPERIMENTAL INVESTIGATION OF A FLAPPING WING MODEL: SOME CHALLENGES FROM UNSTEADY AERODYNAMICS
TSFP DIGITAL LIBRARY ONLINE, Vol.5, 2007, issue
Tatjana Hubel, Cameron Tropea
Transition of a Separated Boundary Layer past a Semi-circular Leading-edge Aerofoil Model for Varying Angles of Attack: An Experimental Investigation
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017), Vol.0, 2017, issue
K. Anand, K. Kannan, V. Vekataraman
ENHANCEMENT OF FLOW-JET COMBINED BOILING HEAT TRANSFER OF FC-72 OVER MICRO-PIN-FINNED SURFACES
Journal of Enhanced Heat Transfer, Vol.19, 2012, issue 6
Yonghai Zhang, Dong Guo, Jin-Jia Wei
FLOW VISUALIZATION OF PARALLEL VORTEX-AIRFOIL INTERACTION
Journal of Flow Visualization and Image Processing, Vol.4, 1997, issue 1
Jerry M. Chen, Yiu-Tin Shieh
EXPERIMENTAL INVESTIGATIONS OF WING LIFT CONTROL BY ACTUATORS DISTRIBUTED ON THE WING SURFACE
TsAGI Science Journal, Vol.48, 2017, issue 1
Andrey Yuryevich Urusov, Maxim Vladimirovich Ustinov, Jacob Shmerkovich Flaxman, Aleksandr Gennadievich Nalivaiko, Aleksandr Aleksandrovich Uspenskii