Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
Journal of Flow Visualization and Image Processing
SJR: 0.11 SNIP: 0.312 CiteScore™: 0.1

ISSN Imprimir: 1065-3090
ISSN En Línea: 1940-4336

Journal of Flow Visualization and Image Processing

DOI: 10.1615/JFlowVisImageProc.2017020436
pages 93-116

FREQUENCY-DEPENDENT FLOW RESPONSE OF A HIGH-SPEED RECTANGULAR SYNTHETIC JET

Stephen A. Solovitz
Washington State University Vancouver, 14204 NE Salmon Creek Ave., Vancouver, WA, USA 98686
Omidreza Ghaffari
EVATEG Center, Ozyegin University, Istanbul, Turkey
Mehmet Arik
EVATEG Center, Ozyegin University, Istanbul, Turkey

SINOPSIS

As the size of electronic systems shrink, thermal management techniques must remove high heat fluxes with tight volumes. Synthetic jets can provide a compact solution, using an oscillating mechanism to produce a time-averaged jet flow with ambient fluid alone. These devices are strongly dependent on operating frequency, achieving their highest speeds near the jet resonant conditions. Unfortunately, this often leads to unwelcome acoustic issues, limiting their range of applications. To address this, we consider the flow performance of an impinging, rectangular synthetic jet at a range of driving frequencies, both on and off of mechanical resonant peaks. Through phase-locked particle image velocimetry (PIV), we demonstrate a significant difference in the flow structures below and above the resonant condition. Below the resonant frequency, the flow response is largely independent of frequency, with only one vortex present between the actuator orifice and an impinging wall. Above resonance, there are additional eddies near the device centerline, with three vortices located within four hydraulic diameters of the impingement point. These vortices retain their nondimensional vorticity longer than at sub-resonant conditions, resulting in nearly identical heat transfer in spite of a lower Reynolds number. These flow responses can be represented with a critical wall spacing, Hcrit = Uo/2f, where the impingement distance is tuned to the actuator frequency.


Articles with similar content:

FLOW AND HEAT TRANSFER FOR JET IMPINGEMENT ARRAYS WITH LOCAL EXTRACTION
TSFP DIGITAL LIBRARY ONLINE, Vol.6, 2009, issue
Christopher J. Elkins, Terri B. Hoberg, Andrew J. Onstad, John K. Eaton
HEAT TRANSFER IN STEADY-PERIODIC FLOWS OVER HEATED MICROWIRES
International Heat Transfer Conference 13, Vol.0, 2006, issue
Serhat Yesilyurt, G. Göktuğ , Meric Ozcan
JET ARRAY IMPINGEMENT COOLING LOCAL NUSSELT NUMBER VARIATIONS: EFFECTS OF HOLE ARRAY SPACING, JET-TO-TARGET PLATE DISTANCE, AND REYNOLDS NUMBER
Heat Transfer Research, Vol.47, 2016, issue 2
Michael D. Fox, Mark McQuilling, Junsik Lee, Zhong Ren, Mary Jennerjohn, Hee-Koo Moon, Phillip Ligrani
Film cooling effectiveness for a single row of discrete injection holes - influence of hole orientation, shape and blowing rate
International Heat Transfer Conference 12, Vol.14, 2002, issue
Sangjo Han, Richard J. Goldstein
CROSS FLOW INFLUENCE UPON IMPINGEMENT CONVECTIVE HEAT TRANSFER IN CIRCULAR ARRAYS OF JETS : A GENERAL CORRELATION
International Heat Transfer Conference 7, Vol.6, 1982, issue
G. Martinez, S. Galant