High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
Publicado 4 números por año
ISSN Imprimir: 1093-3611
ISSN En Línea: 1940-4360
IF:
0.4
Immediacy Index:
0.1
Eigenfactor:
0.00005
JCI:
0.07
SJR:
0.198
SNIP:
0.48
CiteScore™::
1.1
H-Index:
20
Indexed in
Conductive Losses Experienced during CO2 Laser Cutting
Volumen 4,
Edición 2, 2000,
12 pages
DOI: 10.1615/HighTempMatProc.v4.i2.30
SINOPSIS
This paper begins by describing laser cutting in terms of a single energy balance. Analysis of this energy balance reveals that the efficiency of laser cutting decreases as the material thickness is increased. This point is demonstrated by the following experimental programme which investigates thermal losses by conduction from the cut zone. It is also shown that the magnitude of these conductive losses can exceed the laser output power if a laser-oxygen jet is used to cut steels.
311 Vistas de artículos
3 Descargas de artículos
Métrica
Artículos con contenido similar:
Último edicion
DETERMINATION OF THE MASS BALANCE OF HIGH-CARBON FERROCHROME IN A SUBMERGED ARC FURNACE
RHEOLOGICAL BEHAVIOR AND 3D PRINTING OF HIGHLY FILLED ALUMINA-POLYAMIDE FILAMENTS DURING FUSED DEPOSITION MODELING
SCRATCH TESTING OF ZrN COATING ON TI-6AL-4V TITANIUM ALLOY SURFACE PRELIMINARY TREATED BY COMPRESSION PLASMA FLOWS IMPACT
ELECTRON-BEAM SINTERING OF ZIRCONIUM DIOXIDE/TITANIUM CERAMICS FOR MICROELECTRONICS PRODUCTS
THE EFFECT OF THE FLUORINE CONCENTRATION IN A PLASMA-FORMING GAS MIXTURE ON THE CHEMICAL COMPOSITION, SURFACE CHARGE, AND RELIEF PARAMETERS OF FLUOROCARBON COATINGS ON PET
PREPARATION AND THERMOELECTRIC PROPERTIES OF p-TYPE Ag(1-x)Cu(1+x)Te SAMPLES BY SPARK PLASMA SINTERING METHOD
Próximos Artículos
Increasing the wear resistance of titanium alloys by deposition of a modifying coating (Zr,Nb)N
Electron-beam synthesis of zirconia ceramic coatings in the forevacuum pressure range
Preparation and Thermoelectric Properties of P-type Ag(1-x)Cu(1+x)Te Samples by SPS Method
The effect of the fluorine concentration in a plasma-forming gas mixture on the chemical composition, surface charge and relief parameters of fluorocarbon coatings on PET
Electron beam sintering of zirconium dioxide/titanium ceramics for microelectronics products