Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
ESCI SJR: 0.176 SNIP: 0.48 CiteScore™: 1.3

ISSN Imprimir: 1093-3611
ISSN En Línea: 1940-4360

High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes

DOI: 10.1615/HighTempMatProc.v6.i4.80
10 pages

TITANIUM PLASMA UNDER LASER WELDING CONDITIONS

J. Hoffman
Institute of Fundamental Technological Research - Polish Academy of Sciences 00-049 Warsaw, Swietokrzyska 21, Poland
Z. Szymanski
Instytut Podstawowych Problemow Techniki, PAN Swietokrzyska 21, 00-049 Warszawa, Poland

SINOPSIS

Experimental study of titanium plasma under laser welding conditions is presented. Both plasma plume temperature and radiation oscillations are studied. Welding was done with the continuous wave CO2 laser, Photon Sources VFA 2500, operating at the power of 1ё2 kW. Emission spectra from laser produced plasmas were measured with a 1.3 m focal length spectrograph and a 1254 Silicon Intensified Target (SIT) detector connected to EG&G'PARC Optical Multichannel Analyzer (ОМА) III. Welded material was titanium alloy sheets OT-4 (containing besides Ti, 1.5% Al, and 1.3% Mn) 1-2.5 mm thick. The average electron temperature obtained from different Ti II spectral lines was ~14500 К near the metal surface and decreased to ~8000 К at a distance of 2 mm from the surface. The Fourier analysis of the fluctuations of plasma radiation observed during laser welding has also been made. Plasma fluctuations were registered both in monochromatic and broad band radiation with the use of monochromator and photomultiplier or photodiode. In the case of thin, 1 mm, sheets power spectral densities of the signals contain peaks at frequencies of 1.4 and 4 kHz, which are consistent with the theoretical model of keyhole oscillations.


Articles with similar content:

PLASMA OSCILLATIONS DURING cw CO2 LASER WELDING
High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes, Vol.5, 2001, issue 4
J. Kurzyna, Z. Szymanski, J. Hoffman
HIGH-POWER DOUBLE-PULSE GENERATOR FOR POWER SUPPLY TO PULSED HIGH-CURRENT ACCELERATOR
High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes, Vol.21, 2017, issue 4
G. E. Remnev, I. N. Pyatkov, Mikhail V. Zhuravlev, M. I. Kaikanov, M. V. Belyakov, A. V. Tikhonov, I. A. Koryashov
EXPRESS ANALYSIS OF PARAMETERS OF HIGH ENTHALPY PLASMA JETS
High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes, Vol.11, 2007, issue 4
A. A. Belevtsev, E. Kh. Isakaev, V. F. Chinnov
TRANSCEIVER FOR 130-134 GHZ BAND DIGITAL RADIO RELAY SYSTEM
Telecommunications and Radio Engineering, Vol.72, 2013, issue 17
Anatoly Ivanovich Fisun, S.Ye. Kuzmin, Oleg I. Belous, Mikhail E. Ilchenko, T. M. Narytnyk, V.N. Radzikhovsky
SUPER HIGH RATE DEPOSITION OF HOMO- AND HETERO-EPITAXIAL SILICON THICK FILMS BY MESO-PLASMA CVD
High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes, Vol.11, 2007, issue 1
M. Kambara