Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
Atomization and Sprays
Factor de Impacto: 1.262 Factor de Impacto de 5 años: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimir: 1044-5110
ISSN En Línea: 1936-2684

Volumes:
Volumen 29, 2019 Volumen 28, 2018 Volumen 27, 2017 Volumen 26, 2016 Volumen 25, 2015 Volumen 24, 2014 Volumen 23, 2013 Volumen 22, 2012 Volumen 21, 2011 Volumen 20, 2010 Volumen 19, 2009 Volumen 18, 2008 Volumen 17, 2007 Volumen 16, 2006 Volumen 15, 2005 Volumen 14, 2004 Volumen 13, 2003 Volumen 12, 2002 Volumen 11, 2001 Volumen 10, 2000 Volumen 9, 1999 Volumen 8, 1998 Volumen 7, 1997 Volumen 6, 1996 Volumen 5, 1995 Volumen 4, 1994 Volumen 3, 1993 Volumen 2, 1992 Volumen 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v10.i2.40
20 pages

CHARACTERIZATION OF PROTOTYPE HIGH-PRESSURE SWIRL INJECTOR NOZZLES, PART I: PROTOTYPE DEVELOPMENT AND INITIAL CHARACTERIZATION OF SPRAYS

Changsoo Jang
Department of Mechanical Engineering, KAIST, Taejon, Korea
Choongsik Bae
Department of Mechanical Engineering, Korea Advanced Institute of Science and Technology, 373-1, Gusong-dong, Yuseong-gu, Daejon, 305-701, Republic of Korea
Sangmin Choi
Department of Mechanical Engineering, Korea Advanced Institute of Science and Technology, Yusong-gu, Taejon, Korea

SINOPSIS

Basic characteristics of prototype intermittent swirl-generating nozzles for gasoline direct injection were investigated. These prototype swirl nozzles were fabricated by modifying commercial multipoint injection (MPI) nozzles to operate at higher pressures. Experimental parameters included injection pressure, injection duration, and ambient pressure. Spray tip penetration and atomization performance were examined as a function of these parameters. Droplet mean diameter, D32, of the swirl nozzle ranged from 20 to 28 μm at an injection pressure of 5 MPa, which was about 30% smaller than that of the base MPI nozzles. Atomization characteristic was closely related to the overall velocity of the injected droplet cloud, ambient air density, and cone angle. Drop size distributions were found to fit to a Rosin-Rammler distribution and to be less dispersed than those of the air-assisted fuel injector.