Suscripción a Biblioteca: Guest
Portal Digitalde Biblioteca Digital eLibros Revistas Referencias y Libros de Ponencias Colecciones
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN Imprimir: 2152-5102
ISSN En Línea: 2152-5110

Volumes:
Volumen 46, 2019 Volumen 45, 2018 Volumen 44, 2017 Volumen 43, 2016 Volumen 42, 2015 Volumen 41, 2014 Volumen 40, 2013 Volumen 39, 2012 Volumen 38, 2011 Volumen 37, 2010 Volumen 36, 2009 Volumen 35, 2008 Volumen 34, 2007 Volumen 33, 2006 Volumen 32, 2005 Volumen 31, 2004 Volumen 30, 2003 Volumen 29, 2002 Volumen 28, 2001 Volumen 27, 2000 Volumen 26, 1999 Volumen 25, 1998 Volumen 24, 1997 Volumen 23, 1996 Volumen 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v25.i1-3.290
pages 329-338

Convective Heat Transfer from a Heated Convex Cylinder with an Axisymmetric Backward-Facing Step

K. C. Kim
Department of Mechanical and Production Engineering, Pusan National University, Pusan, Korea
M. Niaki
Department of Mechanical Engineering, University of Ottawa, Ottawa, Canada
Y. P. Lee
Department of Mechanical Engineering, University of Ottawa, Ottawa, Ontario, Canada, KIN 6N5

SINOPSIS

Local heat transfer coefficients were measured in the separating, reattaching and redeveloping axisymmetric regions of turbulent boundary layer over the wall of convex cylinders with a uniform wall heat flux. Measurements were made with three different diameters of cylinders with five different diameters of the obstructions. The range of Reynolds number based on step height was between 4000 to 100000.
The study demonstrates that the maximum Nusselt number increases with decreasing cylinder radius and are always greater than those for the two-dimensional backward-facing step flow at the same conditions of the step height and flow velocity. It was also observed that the heat transfer in the redeveloping region increases with an increase in the radius convex curvature. An empirical equation is proposed for the Nusselt number at the reattachment point, correlated as a function of the Reynolds number and the diameter ratio.


Articles with similar content:

An Insertion Technique Using the Transient Method with Liquid Crystals For Enhanced Heat Transfer Measurements in Ducts
Journal of Enhanced Heat Transfer, Vol.1, 1994, issue 2
Xiaojun Terry Yan, James W. Baughn, Jon L. Roby
EXPERIMENTAL STUDY OF THE DISSIMILARITY BETWEEN HEAT TRANSFER AND DRAG AT DIMPLED SURFACES IN THE FLOW, DISTURBED BY THE CYLINDER ROD
International Heat Transfer Conference 16, Vol.14, 2018, issue
Andrey G. Zditovets, Yu. A. Vinogradov , Mark M. Strongin, N. A. Kiselev
Rough-Wall Heat Transfer in Tbrbulent Boundary Layers
International Journal of Fluid Mechanics Research, Vol.25, 1998, issue 1-3
M. H. Hosni, H. W. Coleman, Robert P. Taylor
NUMERICAL INVESTIGATION OF INTERNAL FLOW AND HEAT TRANSFER BETWEEN CYLINDER PIPES
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2015, issue
Ganbat Davaa, Odgerel Jambal
HEAT TRANSFER FROM A CYLINDER COVERED WITH A POROUS LAYER IN CROSS-FLOW
ICHMT DIGITAL LIBRARY ONLINE, Vol.4, 2001, issue
Bassam A/K Abu-Hijleh