Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Journal of Porous Media
Facteur d'impact: 1.49 Facteur d'impact sur 5 ans: 1.159 SJR: 0.43 SNIP: 0.671 CiteScore™: 1.58

ISSN Imprimer: 1091-028X
ISSN En ligne: 1934-0508

Volumes:
Volume 22, 2019 Volume 21, 2018 Volume 20, 2017 Volume 19, 2016 Volume 18, 2015 Volume 17, 2014 Volume 16, 2013 Volume 15, 2012 Volume 14, 2011 Volume 13, 2010 Volume 12, 2009 Volume 11, 2008 Volume 10, 2007 Volume 9, 2006 Volume 8, 2005 Volume 7, 2004 Volume 6, 2003 Volume 5, 2002 Volume 4, 2001 Volume 3, 2000 Volume 2, 1999 Volume 1, 1998

Journal of Porous Media

DOI: 10.1615/JPorMedia.v12.i10.20
pages 939-954

Highly Porous Metal Foams: Effective Thermal Conductivity Measurement Using a Photothermal Technique

Mourad Fetoui
Ecole Nationale d'Ingénieurs de Monastir, Laboratoire d'Etudes des Systèmes Thermiques et Energétiques, Avenue Ibn Eljazzar, 5019 Monastir, Tunisie
Fethi Albouchi
Laboratoire d'Etudes des Systèmes Thermiques et Energétiques, Ecole Nationaled 'Ingénieurs de Monastir, Tunisia
Fabrice Rigollet
Aix Marseille Univ, CNRS, IUSTI
Sassi Ben Nasrallah
Laboratoire d'Études des Systèmes Thermiques et Énergétiques, Ecole Nationale d'Ingénieurs de Monastir, Monastir 5019 Tunisie

RÉSUMÉ

The effective thermal conductivity of highly porous metal foams is measured using a photothermal method with a crenel heating excitation. This method is based on a nondestructive technique. The foam is sandwiched between two thin aluminum plates. The front face of the three-layered structure is submitted to a heat flux and the temperature rise on the rear face is recorded using an infrared camera. Measurements are reported on several foams. The parameter identification is performed by the minimization of the ordinary least squares objective function comparing the measured temperatures to the response of a thermal model function of thermophysical parameters, built with thermal quadruple formalism. The used iterative algorithm is based on the Gauss-Newton method. The obtained results are compared to the literature values and a good agreement is noted.


Articles with similar content:

Measurement of the Effective Thermal Conductivity of Powders Using a Three-Layer Structure
Journal of Porous Media, Vol.10, 2007, issue 6
Sassi Ben Nasrallah, Fethi Albouchi, Foued Mzali
SYNERGESTIC APPROACH FOR THE SIMULTANEOUS ESTIMATION OF HEAT TRANSFER COEFFICIENT AND HEAT FLUX USING FIN FROM STEADY STATE HEAT TRANSFER EXPERIMENTS
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2015, issue
Gnanasekaran N., K. Srinivasa Sagar, Harsha Kumar MK, Sharath Kumar
THE USE OF GA AND PSO FOR THE INVERSE ESTIMATION OF HEAT FLUX IN A CONJUGATE HEAT TRANSFER PROBLEM
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017), Vol.0, 2017, issue
Harsha Kumar, N. Gnanasekaran, PS Vishweshwara
Direct-Inverse Analysis of Heat Transfer in Micro-Models of Porous Media
International Heat Transfer Conference 15, Vol.40, 2014, issue
Carolina Palma Naveira-Cotta
A simple model for estimating specific heat and enthalpy versus temperature in the range of phase change. Application to food products
International Heat Transfer Conference 12, Vol.28, 2002, issue
Francisco Alhama, Joaquin Zueco, Carlos F. Gonzalez-Fernandez