Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Journal of Porous Media
Facteur d'impact: 1.49 Facteur d'impact sur 5 ans: 1.159 SJR: 0.504 SNIP: 0.671 CiteScore™: 1.58

ISSN Imprimer: 1091-028X
ISSN En ligne: 1934-0508

Volumes:
Volume 22, 2019 Volume 21, 2018 Volume 20, 2017 Volume 19, 2016 Volume 18, 2015 Volume 17, 2014 Volume 16, 2013 Volume 15, 2012 Volume 14, 2011 Volume 13, 2010 Volume 12, 2009 Volume 11, 2008 Volume 10, 2007 Volume 9, 2006 Volume 8, 2005 Volume 7, 2004 Volume 6, 2003 Volume 5, 2002 Volume 4, 2001 Volume 3, 2000 Volume 2, 1999 Volume 1, 1998

Journal of Porous Media

DOI: 10.1615/JPorMedia.v14.i9.50
pages 805-814

A STUDY OF HEAT TRANSFER AND PRESSURE DROP DURING CONDENSATION AND EVAPORATION PROCESSES IN POROUS MEDIA, USING EXPERIMENTAL WORK AND DIMENSIONAL ANALYSIS: A CASE STUDY OF CARBON DIOXIDE (CO2)

Mohammad Tarawneh
The Hashemite University, Zarqa 13115 Jordan
A. Alshqirate
Al-Shoubak University College, Al-Balqa' Applied University, Al-Salt, Jordan
Mahmoud Ahmad Hammad
University of Jordan

RÉSUMÉ

This work presents experimental and analytical studies of convection change phase heat transfer coefficient and pressure drop during flow inside tubes filled with porous media (sand). Condensation and evaporation processes were considered. Carbon dioxide was used as a flowing fluid over a wide range of inlet pressures, porosities, and mass flow rates. The pressure drop was found to be significantly reasonable in condensation and negligible for evaporation processes. The experimental results of the convective heat transfer coefficient and pressure drop during these flows were obtained, listed as experimental data, and used to develop empirical correlations using the dimensional analysis method. The analytical data produced from developed correlations were listed. Comparison between experimental results and those obtained analytically proved to be compatible with an average standard deviation (ASD) of 5.97% for pressure drop, while for the convective heat transfer coefficient during condensation process the ASD was 7.35%, and for the convective heat transfer coefficient during evaporation processes the ASD was 4.6%.


Articles with similar content:

TWO-DIMENSIONAL AXISYMMETRIC MODELING OF COMBUSTION IN AN IRON ORE SINTERING BED
Special Topics & Reviews in Porous Media: An International Journal, Vol.4, 2013, issue 4
Saeed Sadeghi Lafmejani, Masoud Panjepour, Mohsen Davazdah Emami, Salman Sohrabi
COMPARISON BETWEEN PERFORMANCE MEASUREMENTS AND COMPUTER PREDICTIONS FOR A 1.4 MW AIR-COOLED CONDENSER
International Heat Transfer Conference 10, Vol.21, 1994, issue
J. A. R. Henry, T. Ralston, M. S. L. McLean
NUMERICAL SIMULATION OF PROCESSES OCCURRING IN A STEAM−WATER MIXING HEATER
Heat Transfer Research, Vol.46, 2015, issue 9
Jian Liu, Xinghui Zhang, Xiujuan Zhang, Xingfang Zhang, Junhui Zhang, Sheng Wu
EVAPORATOR USING HEAT PIPE HEAT EXCHANGER FOR A HEAT RECOVERY SYSTEM
Heat Pipe Science and Technology, An International Journal, Vol.5, 2014, issue 1-4
F. Chejne J., L. A. Betancur A.
HEAT TRANSFER ENHANCEMENT OF AIR-WATER MIST FLOW IMPINGING ON ISOTHERMAL PLATE
Transport Phenomena in Thermal Engineering. Volume 2, Vol.0, 1993, issue
Bo Liu, Shao-Yen Ko