French
English
Русский
中文
日本語
Português
Spain
German
Facteur d'impact:
0.562
Facteur d'impact sur 5 ans:
0.605
SJR:
0.175
SNIP:
0.361
CiteScore™:
0.33
ISSN Imprimer: 1065-5131
Volumes:
|
 An Official Journal of the American Society of Thermal and Fluids Engineers Journal of Enhanced Heat Transfer
DOI: 10.1615/JEnhHeatTransf.v3.i4.10
pages 233-257 A Review of Flow Boiling Heat Transfer with Twisted Tape Inserts
D. P. Shatto
Department of Mechanical Engineering Texas A&M University College Station, TX 77843, USA
G. P. Peterson
Rensselaer Polytechnic Institute, Troy, USA; Depatment of Mechanical Engineering Texas A&M University, College Station, TX 77843-3123, USA; School of Mechanical Engineering, Georgia Institute of Technology, Atlanta 30332, USA RÉSUMÉThis report reviews experimental investigations of in-tube flow boiling enhancement using twisted tape inserts. Special aspects of the experimental methods used in these studies are described in detail, and the general trends observed in the results are presented. Methods of mathematically characterizing the geometric parameters associated with swirl flow are introduced, and the theoretical relationships between swirl flow and axial flow boiling are described. Previously proposed empirical and semi-empirical predictive methods are presented for heat transfer and pressure drop with twisted tape inserts in various convective boiling regimes. These existing correlations are compared, and recommendations are made regarding experimental methods, design practices, and the use of existing predictive methods. Articles with similar content:
FLOW BOILING HEAT TRANSFER WITH TWISTED TAPE INSERTS
Journal of Enhanced Heat Transfer, Vol.24, 2017, issue 1-6 D. P. Shatto, G. P. Peterson
Enhancement of Heat Transfer in Swirled Boiling Flows
Heat Transfer Research, Vol.40, 2009, issue 7 Arthur E. Bergles, Yury A. Kuzma-Kichta
AUGMENTATION OF CONDENSATION HEAT TRANSFER BY INTERNALLY FINNED TUBES AND TWISTED TAPE INSERTS
International Heat Transfer Conference 7, Vol.11, 1982, issue N. Z. Azer, S. A. Said
ON A POSSIBILITY OF OPTIMIZATION OF STRUCTURAL PARAMETERS AND OPERATING CONDITIONS OF TRANSPIRATION COOLING SYSTEM EMPLOYED IN THE THERMO-STRESSED GAS TURBINE BLADES
Advances in Heat Transfer Engineering, Vol.1, 2003, issue Eugene M. Seliverstov, Yury V. Polezhaev
Flow boiling of R-134a in a minichannel plate evaporator with augmented surface
International Heat Transfer Conference 12, Vol.50, 2002, issue Michael M. Ohadi, Francis Henrique Ramos Franca, Majid Molki, A. P. Rupani |