Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Computational Thermal Sciences: An International Journal
ESCI SJR: 0.244 SNIP: 0.434 CiteScore™: 0.7

ISSN Imprimer: 1940-2503
ISSN En ligne: 1940-2554

Computational Thermal Sciences: An International Journal

DOI: 10.1615/ComputThermalScien.2013006358
pages 215-226

WATER DROPLET EVAPORATION AT HIGH GAS PRESSURE AND TEMPERATURE LEVELS − COMPARISON OF EXPERIMENTAL RESULTS WITH A ONE-DIMENSIONAL SIMULATION

Botond Barabas
Department of Mechanical Engineering, University of Duisburg-Essen
A. Kefalas
Department of Mechanical Engineering, University of Duisburg-Essen
J. P. Schnitzler
Department of Mechanical Engineering, University of Duisburg-Essen
A. Rossetti
Department of Mechanical Engineering, University of Duisburg-Essen
F.-K. Benra
Department of Mechanical Engineering, University of Duisburg-Essen
H. J. Dohmen
Department of Mechanical Engineering, University of Duisburg-Essen

RÉSUMÉ

Water injection into gas turbines has been the subject of investigations for decades, due to a high power and efficiency augmentation potential compared to the simple gas turbine cycle. Based on former research at ambient injection conditions, some technologies have already been realized, e.g., inlet fogging. Further applications of water injection at higher temperature and pressure levels are limited because of few experimental data. In order to gain fundamental understanding of these boundary conditions, a novel test facility for droplet evaporation investigations has been built up at the Department of Mechanical Engineering at University of Duisburg-Essen. The resulting spray patterns are recorded by a laser-based measuring technology, phase Doppler particle analyzer. In this paper, experimental results from the test facility are compared to simulation results of a one-dimensional model for droplet evaporation. The focus of this investigation is on the accordance of the simulation results with the experimental data at high pressure and temperature levels.


Articles with similar content:

INTERNAL FLOW CHARACTERIZATION ON AN ECN GDi INJECTOR
Atomization and Sprays, Vol.26, 2016, issue 9
Jaime Gimeno, P. Marti-Aldaravi, Raul Payri, D. Vaquerizo
SPRAY DIAGNOSTICS FOR THE TWENTY-FIRST CENTURY
Atomization and Sprays, Vol.10, 2000, issue 3-5
William Bachalo
EFFECT OF ETHANOL AND AMBIENT PRESSURE ON PORT-FUEL-INJECTION SPRAYS IN AN OPTICALLY ACCESSIBLE INTAKE CHAMBER
Atomization and Sprays, Vol.21, 2011, issue 5
Evatt R. Hawkes, Srinivas Padala, Sanghoon Kook
EVALUATION OF THE VAPORIZATION ENERGY OF A DIESEL AND A BIODIESEL SPRAY VIA INFRARED IMAGING AND 1D MODEL
Computational Thermal Sciences: An International Journal, Vol.11, 2019, issue 4
Luigi Sequino, Ezio Mancaruso, Bianca Maria Vaglieco
VAPORIZATION CHARACTERISTICS OF ETHANOL AND 1-PROPANOL DROPLETS AT HIGH TEMPERATURES
Atomization and Sprays, Vol.22, 2012, issue 3
Benoite Lefort, Sanisah Binti Saharin, Luis Le Moyne, Christian Chauveau, Raed Kafafy, Celine Morin