Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Atomization and Sprays
Facteur d'impact: 1.262 Facteur d'impact sur 5 ans: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimer: 1044-5110
ISSN En ligne: 1936-2684

Volumes:
Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v19.i11.20
pages 1013-1029

GAS ENTRAINMENT CHARACTERISTICS OF DIESEL SPRAY DURING END OF INJECTION TRANSIENT

Seoksu Moon
AIST, Japan
Keiya Nishida
Department of Mechanical System Engineering, University of Hiroshima, 1-4-1 Kagamiyama, Higashi-Hiroshima, Hiroshima 739-8527, Japan
Yuhei Matsumoto
Department of Mechanical System Engineering, University of Hiroshima, 1-4-1 Kagamiyama, Higashi-Hiroshima 739-8527, Japan
Jeekuen Lee
Faculty of Precision Mechanical Engineering, 664-14, 1-ga, Duckjin-dong, Duckjin-gu, Jeonju, Chonbuk, 561-756, Republic of Korea

RÉSUMÉ

This paper reports the effect of injection parameters such as nozzle hole diameter and injection duration on gas entrainment of diesel sprays during the end of injection transient. The entrained gas flow fields of transient diesel sprays were measured using particle image velocimetry incorporated with the laser-induced fluorescence technique. To investigate the effect of injection parameters, two nozzles with different hole diameters and two injection modes (a quasi-steady injection with long injection duration and a transient injection with short injection duration) were applied. In all test cases, in order to compensate for the decreased mass inside the spray caused by the decrease in fuel supply, gas entrainment during the end of injection transient increased compared to that of the quasi-steady state. In the case of the nozzle with a larger hole diameter, the steeper decrease in fuel mass flow rate during the end of injection transient resulted in a higher rate of entrained gas flow compared to that of the nozzle with the smaller nozzle hole diameter. However, this increasing rate of gas flow rate appears similar regardless of applied injection modes, a quasi-steady injection with long injection duration and a transient injection with short injection duration, supposedly due to the similar decreasing rate of fuel mass flow during the end of injection transient. The decrease in mass inside the spray (mass disturbance) propagated from the nozzle tip region to downstream with time. This propagation speed of mass disturbance inside the spray was affected by the penetrating rate of the spray during injection, and increased through the nozzle with a larger hole diameter and quasi-steady injection with longer injection duration.


Articles with similar content:

EFFECT OF NOZZLE HOLE GEOMETRY ON NON-EVAPORATING DIESEL SPRAY CHARACTERISTICS AT HIGH-PRESSURE INJECTION
Atomization and Sprays, Vol.22, 2012, issue 1
Jangsik Kong, Choongsik Bae
EFFECT OF SPLIT INJECTION ON THE MACROSCOPIC DEVELOPMENT AND ATOMIZATION CHARACTERISTICS OF A DIESEL SPRAY INJECTED THROUGH A COMMON-RAIL SYSTEM
Atomization and Sprays, Vol.16, 2006, issue 5
Rolf D. Reitz, Chang Sik Lee, Sungwook Park
DIRECT CONTACT BOILING OF IMMISCIBLE LIQUIDS
International Heat Transfer Conference 10, Vol.12, 1994, issue
Maurizio Cumo, Gian Piero Celata, G. Ingui, F. Gugliermetti, Francesco D'Annibale
WAVE CHARACTERISTICS OF LIQUID SHEETS WITH IMPINGING AIR JETS
Atomization and Sprays, Vol.2, 1992, issue 2
Norman Chigier, Hasan Eroglu
Characterization of Cavitation Flow in a Simple Hole Nozzle
International Journal of Fluid Mechanics Research, Vol.24, 1997, issue 1-3
Keiya Nishida, Steven L. Ceccio, Hiroyuki Hiroyasu, Dennis N. Assanis, N. Tamaki