Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Atomization and Sprays
Facteur d'impact: 1.262 Facteur d'impact sur 5 ans: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimer: 1044-5110
ISSN En ligne: 1936-2684

Volumes:
Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v1.i3.40
pages 303-318

IMPINGING DIESEL SPRAY DYNAMICS

R. Zurlo
Carnegie Mellon University, Pittsburgh, Pennsylvania 15213
Norman Chigier
Department of Mechanical Engineering Carnegie-Mellon University, Pittsburgh, PA 15213-3890

RÉSUMÉ

A study has been made of the physics of a pulsed diesel spray impacting on a flat plate under atmospheric conditions. Photographs of the impinging diesel spray reveal an impingement region, a liquid buildup region, a ligament region at the edge of the liquid buildup region, and a droplet region near the outer edge of the impinged spray. Two different reatomization mechanisms for the portion of the spray that hits the flat plate are shown to exist. The dominant reatomization mechanism, ligament formation, may not be applicable to a practical diesel engine because of the concave geometry of the piston bowl. A modification of the polarization ratio technique allowed nearly instantaneous measurements of droplet size to be made. Measurements of droplet size show that droplet shattering is the other reatomization mechanism.


Articles with similar content:

MODELING THE EFFECTS OF GAS DENSITY ON THE DROP TRAJECTORY AND BREAKUP SIZE OF HIGH-SPEED LIQUID DROPS
Atomization and Sprays, Vol.9, 1999, issue 5
Rolf D. Reitz, C. H. Lee
A DROP-SHATTERING COLLISION MODEL FOR MULTIDIMENSIONAL SPRAY COMPUTATIONS
Atomization and Sprays, Vol.9, 1999, issue 3
Rolf D. Reitz, Thierry L. Georjon
EXPERIMENTAL INVESTIGATIONS ON A PIEZO-ACTIVATED HOLLOW CONE INJECTOR − PART II: THE INFLUENCE OF NEEDLE LIFT ON DROPLET SIZE DISTRIBUTIONS AND VORTEX FORMATION
Atomization and Sprays, Vol.24, 2014, issue 10
Graham Wigley, Konstantinos Boulouchos, B. Schneider, Andreas Schmid
CHARACTERISTICS OF HOLLOW CONE SPRAYS IN CROSSFLOW
Atomization and Sprays, Vol.21, 2011, issue 4
Mario F. Trujillo, Jian Gao, Suraj Deshpande
IMPINGEMENT OF HIGH-PRESSURE GASOLINE SPRAYS ON ANGLED SURFACES
Atomization and Sprays, Vol.16, 2006, issue 6
Jim H. Whitelaw, J. M. Nouri