Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Atomization and Sprays
Facteur d'impact: 1.262 Facteur d'impact sur 5 ans: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimer: 1044-5110
ISSN En ligne: 1936-2684

Volumes:
Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2015011524
pages 675-694

EXPERIMENTAL INVESTIGATION OF SPRAY CHARACTERISTICS OF DIESEL-METHANOL-WATER EMULSION

Dongyin Wu
Institute of Mechanics, Chinese Academy of Sciences, Beijing 100080; School of Energy & Power Engineering, Xi'an Jiaotong University, 710049, Xi'an, China
Wuqiang Wang
School of Energy & Power Engineering, Xi'an Jiaotong University, 710049, Xi'an, China
Zhenzhou Pang
School of Energy & Power Engineering, Xi'an Jiaotong University, 710049, Xi'an, China
Shenteng Cao
School of Energy & Power Engineering, Xi'an Jiaotong University, 710049, Xi'an, China
Junjie Yan
State Key Laboratory of Multiphase Flow in Power Engineering, School of Energy & Power Engineering, Xi'an Jiaotong University, Xi'an, 710049, P. R. of China

RÉSUMÉ

The spray characteristics were investigated for the Diesel-methanol-water (DMW) emulsion and commercial Diesel fuel. Droplet diameters and droplet size distributions were measured by Malvern particle size analyzer and spray tip penetration, and cone angles were acquired using the high-speed CCD digital camera. All experiments were conducted by employing a high-pressure fuel injection system under room temperature and pressure. The viscosity property of the experimental liquid was measured by the rotary viscometer to ensure the influence of the liquid physical property on spray characteristics. The changes of the emulsion physical properties, including the dispersed phase content and the emulsifier, caused significant changes of the spray characteristics. It was found that the curve of droplet size distribution of DMW emulsion and Diesel first increased then decreased with the increase of the nominal diameter, but the distribution range of Diesel was narrower than that of DMW emulsion. Furthermore, Sauter mean diameter and other representative drop diameters decreased with the increase of injection pressure, and a higher injection pressure produced finer spray droplets and better distribution uniformity. Under the same conditions, the spray tip penetration and cone angle of DMW emulsion were smaller than that of Diesel, and they decreased with the increase of the dispersed phase content. Meanwhile, a higher viscosity and lower HLB of the emulsifier had a larger atomized particle size and a smaller spray tip penetration and spray cone angle. However, the variation of spray characteristics of different fuels became smaller with increasing injection pressure.


Articles with similar content:

EXPERIMENTAL STUDY ON INJECTION AND MACROSCOPIC SPRAY CHARACTERISTICS OF ETHYL OLEATE, JET FUEL, AND THEIR BLEND ON A DIESEL ENGINE COMMON RAIL SYSTEM
Atomization and Sprays, Vol.25, 2015, issue 9
Dong Han, Zhen Huang, Pengfei Li, He Lin, Chunhai Wang, Yaozong Duan
EFFERVESCENT ATOMIZER OPERATION AND SPRAY CHARACTERISTICS
Atomization and Sprays, Vol.3, 1993, issue 2
J. D. Whitlow, Arthur H. Lefebvre
EFFECT OF INJECTION PARAMETERS ON SPRAY CHARACTERISTICS OF GAS-TO-LIQUID (GTL), BIODIESEL, AND DIESEL FUEL FOR A MULTI-HOLE INJECTOR IN A DIESEL ENGINE
Atomization and Sprays, Vol.25, 2015, issue 12
Chang Sik Lee, Donggon Lee, Hyun Gu Roh, Kibong Choi
AN EXPERIMENTAL STUDY ON GASOLINE DIRECT-INJECTION SPRAY AND ATOMIZATION CHARACTERISTICS OF ALCOHOL FUELS AND ISOOCTANE
Atomization and Sprays, Vol.21, 2011, issue 5
Himesh Patel, Shanshan Yao, Ji Zhang, Tiegang Fang
Effects of Fuel Viscosity and Ambient Temperature on Spray Characteristics from Multi-Hole Nozzle Injectors
International Journal of Fluid Mechanics Research, Vol.24, 1997, issue 1-3
C. B. Warrick, J. M. Kozma, T. F. Su, Patrick V. Farrell