Abonnement à la biblothèque: Guest
Portail numérique Bibliothèque numérique eBooks Revues Références et comptes rendus Collections
Atomization and Sprays
Facteur d'impact: 1.262 Facteur d'impact sur 5 ans: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN Imprimer: 1044-5110
ISSN En ligne: 1936-2684

Volumes:
Volume 29, 2019 Volume 28, 2018 Volume 27, 2017 Volume 26, 2016 Volume 25, 2015 Volume 24, 2014 Volume 23, 2013 Volume 22, 2012 Volume 21, 2011 Volume 20, 2010 Volume 19, 2009 Volume 18, 2008 Volume 17, 2007 Volume 16, 2006 Volume 15, 2005 Volume 14, 2004 Volume 13, 2003 Volume 12, 2002 Volume 11, 2001 Volume 10, 2000 Volume 9, 1999 Volume 8, 1998 Volume 7, 1997 Volume 6, 1996 Volume 5, 1995 Volume 4, 1994 Volume 3, 1993 Volume 2, 1992 Volume 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v13.i23.20
18 pages

ELECTROHYDRODYNAMICS OF CHARGE INJECTION ATOMIZATION: REGIMES AND FUNDAMENTAL LIMITS

John S. Shrimpton
Energy Technology Research Group, School of Engineering Sciences, University of Southampton, United Kingdom, SO171BJ

RÉSUMÉ

The dynamics and controlling mechanisms of a charge injection electrostatic atomization method for insulating liquids have been investigated using a sharp electrode as a current source, which is placed inside the atomizer and held at a high electrical potential. The method is applicable to highly insulating liquids such as hydrocarbon oils and oil-based solutions, and potential uses of this technology include combustion systems and high-quality spray coating/deposition applications. Subcritical and supercritical flow regimes of atomizer operation are delineated by different types of electrical breakdown. The subcritical flow regime is limited by an insulation failure of the liquid hydrocarbon itself and occurs inside the atomizer. This regime, although of interest to understand the fundamental nature of the electrohydromechanics, does not produce finely atomized sprays. Atomization performance in the supercritical flow regime is characterized by the maximum spray specific charge being limited by a partial discharge in the gas outside the nozzle, around the liquid jet as it emerges from the nozzle. In this case, finely atomized sprays are possible, and with no electrical limitation on the upper flow rate limit. The maximum spray specific charge achievable in the supercritical regime has been found to increase at larger nozzle exit velocities and also for smaller orifice diameters. These two factors, combined with the increased aerodynamic shear acting on the charged liquid jet as it emerges from the orifice at higher velocities, enhances the destabilization of the charged liquid jet to produce finely atomized and well-dispersed sprays of insulating liquids.


Articles with similar content:

SPRAY CHARACTERISTICS OF CHARGE INJECTION ELECTROSTATIC ATOMIZERS WITH SMALL-ORIFICE DIAMETERS
Atomization and Sprays, Vol.16, 2006, issue 4
John S. Shrimpton, A. R. H. Rigit
ELECTRICAL AND SPRAY CHARACTERISTICS OF A MULTIORIFICE CHARGE-INJECTION ATOMIZER FOR ELECTRICALLY INSULATING LIQUIDS
Atomization and Sprays, Vol.20, 2010, issue 4
Agisilaos Kourmatzis, John S. Shrimpton, Jeff Allen
ATOMIZATION OF HIGH-VISCOSITY AND NON-NEWTONIAN FLUIDS BY PREMIXING
Atomization and Sprays, Vol.28, 2018, issue 5
Volfango Bertola, Michele Negri, Tom Baker
SPRAY EVOLUTION IN A TWIN-FLUID SWIRL ATOMIZER
Atomization and Sprays, Vol.18, 2008, issue 5
J. Karnawat, Abhijit Kushari
EFFECT OF BUBBLE GENERATION CHARACTERISTICS ON EFFERVESCENT ATOMIZATION AT LOW GAS-LIQUID RATIO OPERATION
Atomization and Sprays, Vol.20, 2010, issue 3
David S. Nobes, Sina Ghaemi, Payam Rahimi