Library Subscription: Guest
Begell Digital Portal Begell Digital Library eBooks Journals References & Proceedings Research Collections
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.142 SNIP: 0.16 CiteScore™: 0.29

ISSN Print: 2150-766X
ISSN Online: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v5.i1-6.300
pages 284-295

LASER IGNITION CHARACTERIZATION OF N-5 DOUBLE-BASE SOLID PROPELLANT

Grant A. Risha
The Pennsylvania State University-Altoona, Altoona, Pennsylvania 16601, USA
Donald E. Koch
Department of Mechanical and Nuclear Engineering, The Pennsylvania State University, University Park, PA 16802, USA
James R. Harvel
Department of Mechanical and Nuclear Engineering, The Pennsylvania State University, University Park, PA 16802, USA

ABSTRACT

An experimental investigation of the ignitability of various material lots of N-S double-base solid propellant has been conducted. In order to investigate an observable variance in the ignition stages of the N-5 solid propellant lots (EP-A, EP-B, and EP-C), the ignition behavior (including the onset of initial gas evolution, first light emission, and self-sustained ignition) was determined. Original ring-shaped N-S propellant samples were cut into eight equal samples, inserted into the sample holder, and ignited using the radiant heat flux of a high-powered CO2 laser, which produces an infrared laser beam at a wavelength of 10.6 μm. For each test run, the sample was carefully placed in a specially designed carbon-carbon (graphite) sample holder. This laser power delivered to the propellant surface corresponds to the radiative heat flux ranging from 29 to 61 W/cm2. The CO2 laser shutter was set to the calculated for the two raw material lots of N-5 (EP-A and EP-B). The materials lots manufactured in 1984 (EP-B) were found to have more reproducible experimental results. For the 1990 material lots (EP-A), there was less condensed-phase residue after the test ran. The energies supplied from the laser to initiate gas evolution and first light emission from the propellant surface agreed well between both older and newer raw material propellant lots. However, the ignition delay time (tIGN) for the newer N-5 lot is much longer than that of the older N-5 lot. This implies that the thermal pyrolysis induced fragmented species from these two lots are much different. Also, the dependency of tIGN on heat flux had opposite trends. The recovered N-5 propellant sample (EP-C) from a failed gas generator test ran showed a prolonged ignition delay period. The data obtained from six equal segments of a single ring exhibited severe scattering in the measured tIGN. This implies that the material is non-uniform due to exposure to the hot product gases and condensed-phase particles from the Triple Six booster charge.


Articles with similar content:

IGNITION DELAY TIME MEASUREMENT OF A REDUCED SMOKE COMPOSITE SOLID PROPELLANT
International Journal of Energetic Materials and Chemical Propulsion, Vol.12, 2013, issue 2
Bora Yazici, Sertac Curdaneli, A. Ulas
EXPERIMENTAL ANALYSIS OF A MINIMUM SMOKE PROPELLANT IGNITION CHARACTERIZATION
International Journal of Energetic Materials and Chemical Propulsion, Vol.4, 1997, issue 1-6
Mingde Song, Weidong Yang, Lei Du, Hui Wang
TEMPERATURE SENSITIVITY MEASUREMENTS AND REGRESSION BEHAVIOR OF A FAMILY OF BORON-BASED VERY HIGH BURNING RATE PROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.2, 1993, issue 1-6
W. H. Hsieh, R. M. Salizzoni
REACTIONS OF POWDERED ALUMINUM WITH EXPLOSIVES THAT SELECTIVELY FORM CARBON DIOXIDE OR WATER AS OXIDIZERS
International Journal of Energetic Materials and Chemical Propulsion, Vol.15, 2016, issue 4
Larry G. Hill, V. Eric Sanders, Carl Johnson, Bryce C. Tappan, Steve J. Pemberton, Virginia W. Manner, Mark A. Lieber
INVESTIGATION OF SOLID OXIDIZER AND GASEOUS FUEL COMBUSTION PERFORMANCE USING AN ELEVATED PRESSURE COUNTERFLOW EXPERIMENT FOR REVERSE HYBRID ROCKET ENGINE
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 6
Grant A. Risha, Terrence L. Connell, Jr., Reed H. Johansson, Gregory Young, Richard A. Yetter