Library Subscription: Guest
Begell Digital Portal Begell Digital Library eBooks Journals References & Proceedings Research Collections
Heat Transfer Research

Impact factor: 0.930

ISSN Print: 1064-2285
ISSN Online: 2162-6561

Volumes:
Volume 48, 2017 Volume 47, 2016 Volume 46, 2015 Volume 45, 2014 Volume 44, 2013 Volume 43, 2012 Volume 42, 2011 Volume 41, 2010 Volume 40, 2009 Volume 39, 2008 Volume 38, 2007 Volume 37, 2006 Volume 36, 2005 Volume 35, 2004 Volume 34, 2003 Volume 33, 2002 Volume 32, 2001 Volume 31, 2000 Volume 30, 1999 Volume 29, 1998 Volume 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.2016012206
pages 753-765

TRANSIENT HEAT CONDUCTION IN WIRES WITH HEAT SOURCES; LUMPED AND DISTRIBUTED SOLUTION TECHNIQUES

Federico Scarpa
University of Genoa, DIME/TEC, Division of Thermal Energy and Environmental Conditioning Via All'Opera Pia 15 A, 16145 Genoa, Italy
Mattia De Rosa
University of Genoa, DIME/TEC, Division of Thermal Energy and Environmental Conditioning Via All'Opera Pia 15 A, 16145 Genoa, Italy

ABSTRACT

The aim of this study is to test the approximate lumped analysis against the more rigorous distributed parameter approach in the solution of 1D and 2D nonlinear heat conduction problems associated with electrical cables under a current load. The system of partial differential equations governing the distributed parameter model is replaced by a system of ordinary differential equations with total derivatives with respect to time. The number of temperature unknowns is highly reduced and the numerical solution, even though approximate, can be very fast. Furthermore, with the use of the thermal-electrical analogy, the lumped system can be described as an equivalent electric circuit composed of thermal resistances and capacitances properly connected and solved with dedicated software. In this work, the lumped approach is applied to the overheating effect of insulated electric cables under a current load both in a steady and a transient regime. For this application, the lumped methodology can be very useful owing to the presence of several regions of solution domain having negligible internal conductive resistance. The approximate solutions are compared with the distributed parameter approach obtained with a commercial FEM code. An empirical methodology is described for modeling single cables and composite flat cables in such a way as to minimize the difference between the approximate and the more rigorous solution, both in a steady state and in a dynamic regime. The difference can be limited to less than few percent and can be considered fully adequate for industrial design.