ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Telecommunications and Radio Engineering
SJR: 0.202 SNIP: 0.2 CiteScore™: 0.23

ISSN 印刷: 0040-2508
ISSN オンライン: 1943-6009

巻:
巻 78, 2019 巻 77, 2018 巻 76, 2017 巻 75, 2016 巻 74, 2015 巻 73, 2014 巻 72, 2013 巻 71, 2012 巻 70, 2011 巻 69, 2010 巻 68, 2009 巻 67, 2008 巻 66, 2007 巻 65, 2006 巻 64, 2005 巻 63, 2005 巻 62, 2004 巻 61, 2004 巻 60, 2003 巻 59, 2003 巻 58, 2002 巻 57, 2002 巻 56, 2001 巻 55, 2001 巻 54, 2000 巻 53, 1999 巻 52, 1998 巻 51, 1997

Telecommunications and Radio Engineering

DOI: 10.1615/TelecomRadEng.v74.i7.40
pages 601-618

TORCH DISCHARGE RESISTANCE AND FREQUENCY DEPENDENCE OF THE HF-SOURCE VOLTAGE REQUIRED TO SUSTAIN DISCHARGE

A. O. Puzanov
A. Usikov Institute of Radio Physics and Electronics, National Academy of Sciences of Ukraine, 12, Academician Proskura St., Kharkov 61085, Ukraine
A. N. Kuleshov
A. Usikov Institute of Radio Physics and Electronics, National Academy of Sciences of Ukraine, 12, Academician Proskura St., Kharkov 61085, Ukraine
B. P. Yefimov
A. Usikov Institute of Radio Physics and Electronics, National Academy of Sciences of Ukraine, 12, Academician Proskura St., Kharkov 61085, Ukraine

要約

The considered problem is topical because of the necessity to reduce the POWER consumption of the set-up intended for ignition and long-term sustaining of the torch discharge (TD) burning in case of its industrial application, as well as due to the complexity of TD investigations in a wide frequency band. The aim is to develop a technique for measuring the TD resistance, which is its decisive characteristic. The relevant techniques suggested in scientific literature are quite complex and expensive. In this paper, we present some formulae derived to determine the TD resistance in the power range up to 1 kW by measuring the source's minimum voltages required for sustaining TD burning at two frequencies. The frequency dependencies for these voltages have been obtained. Simple estimation expressions for TD parameters have been derived; their accuracy has been compared under various conditions. The limits of the frequency band in which the obtained expressions remain true have been found. The suggested method allows obtain the desired result at a lower cost and with a simpler set-up design. The performed work contributes to a more effective use of material and technical resources.


Articles with similar content:

Quasi-Optical Solid-State Oscillators
Telecommunications and Radio Engineering, Vol.51, 1997, issue 4
B. M. Bulgakov, Aleksander I. Borodkin
NUMERICAL ANALYSIS OF THE TWO-FREQUENCY APPROACH TO DETERMINE TORCH DISCHARGE RESISTANCE WITH OR WITHOUT ITS EQUIVALENT INDUCTANCE BEING TAKEN INTO ACCOUNT
Telecommunications and Radio Engineering, Vol.77, 2018, issue 16
A. O. Puzanov
SYSTEM OF AUTOMATIC FREQUENCY CONTROL OF HETERODYNE OF THE RADAR RECEIVER WITH MAGNETRON TRANSMITTER
Telecommunications and Radio Engineering, Vol.77, 2018, issue 15
I. M. Mytsenko, D. D. Khalameyda
NARROW-BAND MICROWAVE FILTERS OF WIDE APPLICATION
Telecommunications and Radio Engineering, Vol.75, 2016, issue 1
A. V. Strizhachenko
IMPEDANCE AND GENERATION EFFICIENCY OF A PLANAR DIODE WITH RESONANT TUNNELING BOUNDARIES (RTB) BASED ON GaAs
Telecommunications and Radio Engineering, Vol.72, 2013, issue 17
E. D. Prokhorov, О.А. Reutyna, O. V. Botsula