ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Journal of Porous Media
インパクトファクター: 1.49 5年インパクトファクター: 1.159 SJR: 0.43 SNIP: 0.671 CiteScore™: 1.58

ISSN 印刷: 1091-028X
ISSN オンライン: 1934-0508

巻:
巻 22, 2019 巻 21, 2018 巻 20, 2017 巻 19, 2016 巻 18, 2015 巻 17, 2014 巻 16, 2013 巻 15, 2012 巻 14, 2011 巻 13, 2010 巻 12, 2009 巻 11, 2008 巻 10, 2007 巻 9, 2006 巻 8, 2005 巻 7, 2004 巻 6, 2003 巻 5, 2002 巻 4, 2001 巻 3, 2000 巻 2, 1999 巻 1, 1998

Journal of Porous Media

DOI: 10.1615/JPorMedia.v2.i1.50
pages 71-85

Thermal Protection System with Use of Porous Media for a Hypersonic Reentry Vehicle

Hirotoshi Kubota
Department of Aeronautics and Astronautics, Faculty of Engineering, University of Tokyo, 7-3-1 Hongo, Bunkyo, Tokyo 113, Japan
Shunichi Uchida
Department of Aeronautics and Astronautics, University of Tokyo, 7-3-1 Hongo, Bunkyo, Tokyo 113-8656, Japan

要約

The effectiveness of a transpiration-cooled thermal protection system for a hypersonic reentry vehicle consisting of porous material is numerically analyzed with the new concept of coupling of outer free stream and inner flow within the porous matrix. This analysis is more effective in estimation of surface temperature and heat flux to the system compared with previous methods. The transpiration of coolant fluid has great cooling effectiveness as a result of decrease of surface temperature and heat flux, as transpired fluid injected into the outer flow cools the surface as well as creates a moderate temperature gradient near the surface. Increase of back face pressure corresponding to increase of transpiration mass flow causes the lower surface temperature and smaller heat flux. The cooling effectiveness per mass transpiration rate based on decrease of surface temperature is improved by smaller porosity, which shows the superiority of smaller porosity material for practical use.


Articles with similar content:

TWO-PHASE FLOW SIMULATION OF MIST FILM COOLING WITH DIFFERENT WALL HEATING CONDITIONS
International Heat Transfer Conference 13, Vol.0, 2006, issue
X. Li, Ting Wang
FLOW AND TEMPERATURE FIELDS FOLLOWING INJECTION OF A JET NORMAL TO A CROSS STREAM
International Heat Transfer Conference 6, Vol.5, 1978, issue
V. L. Eriksen, Richard J. Goldstein, J. W. Ramsey
ROTATING MINIATURE AND SECTOR HEAT PIPES FOR COOLING GAS TURBINE ROTOR BLADES AND DISKS
Heat Transfer Research, Vol.44, 2013, issue 1
Yiding Cao, Brian Reding, M. Gao
EXPERIMENTAL STUDY OF PRESSURE DROP AND HEAT TRANSFER IN A U-BEND CHANNEL WITH VARIOUS GUIDE VANES AND RIBS
Journal of Enhanced Heat Transfer, Vol.22, 2015, issue 1
Alfonso Niro, Lei Wang, Susanna Cimina, Bengt Sunden, Chenglong Wang
HEAT SINK WITH MULTILAYER OF POROUS MEDIA
Journal of Porous Media, Vol.19, 2016, issue 8
Fatemeh Hassanipour, Arun Karunanithi