ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Journal of Enhanced Heat Transfer
インパクトファクター: 0.562 5年インパクトファクター: 0.605 SJR: 0.175 SNIP: 0.361 CiteScore™: 0.33

ISSN 印刷: 1065-5131
ISSN オンライン: 1026-5511

Journal of Enhanced Heat Transfer

DOI: 10.1615/JEnhHeatTransf.2013007708
pages 179-194

COMPARISON OF THE EFFECTS OF DIFFERENT TYPES OF TUBE INSERTS ON TWO-PHASE FLOW INSTABILITIES

Gokhan Omeroglu
Department of Mechanical Engineering, Faculty of Engineering, Atatürk University
Omer Gomakh
Department of Mechanical Engineering, Faculty of Engineering, Ataturk University
Sendogan Karagoz
Department of Mechanical Engineering, Ataturk University, TR-25240 Erzurum, Turkey
Suleyman Karsli
Department of Mechanical Engineering, Faculty of Engineering, Ataturk University, TR-25300 Erzurum, Turkey

要約

Turbulence promoting inner elements such as rings, wings or winglets, twisted tapes, etc., is widely used in single- and two-phase flows. In this experimental work, the two-phase flow instabilities of forced convection boiling in a horizontal tube with ring- and twisted-tape-type inner elements inside are investigated. In order to analyze the two-phase flow of water, the experiments were conducted under a constant system pressure of 7.5 bar, and a constant heat input of 24 kW was applied to the outer surface of the circular test pipe with constant exit restriction. Three different inlet temperatures (Ti = 15, 25, and 35°C) were used to see the effect of inlet sub-cooling, and the mass flow rate was decreased from 110 to 20 g/s to obtain the characteristic curve. Two different pitch ratios for both the ring and twisted tape were evaluated in terms of stability. The results were evaluated in terms of appropriate variables for both the tube with insertions and the smooth tube. The analysis shows that the pressure drop increases with decreasing mass flow rate for all cases. The presence of the inner elements in the test pipe causes the boundaries of the oscillations to narrow in comparison with smooth tube. On the other hand, with the increase in the effective diameter of the test pipe the boundaries of the oscillations broaden. For each type of insertion, the increase of the pitch ratio makes the system less stable.


Articles with similar content:

INVESTIGATION OF HEAT TRANSFER COEFFICIENT FOR NON-CIRCULAR DUCT WITH TWISTED TAPE INSERT
Second Thermal and Fluids Engineering Conference, Vol.18, 2017, issue
D. A. Kamble, Prathmesh Joshi, R. J. Yadav, Sandip Kore
THE EFFECT OF TURBULENCE PROMOTERS ON HEAT AND MOMENTUM TRANSFER FOR AIR FLOW IN AN ANNULUS
International Heat Transfer Conference 4, Vol.9, 1970, issue
J. J. C. Picot , C. K. Rao
The Effect of Augmented Surfaces on Two-Phase Flow Instabilities in a Horizontal System
Journal of Enhanced Heat Transfer, Vol.2, 1995, issue 4
Omer Comakli, F. Widmann, Sadik Kakac, Y. Ding, Claudia O. Gavrilescu
THERMAL PERFORMANCE OF FURTHER CROSS-INCLINED IN-LINE AND STAGGERED TUBE BANKS
International Heat Transfer Conference 6, Vol.4, 1978, issue
J.L. King, E. M. Smith
Experimental Studies of Condensation Heat Transfer in an Inclined Microfin Tube
International Heat Transfer Conference 15, Vol.3, 2014, issue
Josua Petrus Meyer, Jaco Dirker, Adecunle O. Adelaja