ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Journal of Flow Visualization and Image Processing
SJR: 0.11 SNIP: 0.312 CiteScore™: 0.1

ISSN 印刷: 1065-3090
ISSN オンライン: 1940-4336

Journal of Flow Visualization and Image Processing

DOI: 10.1615/JFlowVisImageProc.2016016100
pages 117-129

THE GROWTH CHARACTERISTICS OF TRANSIENT IMPINGING AXISYMMETRIC TURBULENT JETS

Brian D. Landers
Department of Aerospace Engineering, University of Cincinnati, Cincinnati, OH, USA 45221-0070
Peter J. Disimile
Department of Aerospace Engineering, University of Cincinnati, Cincinnati, OH, USA 45221-0070

要約

This paper presents a study performed to evaluate the growth characteristics of transient impinging axisymmetric turbulent jets at a Reynolds number of 7500 for three different impingement angles (30, 45, and 60 deg). Previous studies have been performed on a single transient turbulent jet as well as steady-state turbulent impinging jets. However, in the case of internal and diesel combustion engines, mixing of the fuel and oxidizer occurs under a transient condition just prior to ignition. This mixing application results from the impingement of these two fluid streams. Therefore, the current study utilizes smoke visualization to characterize the vertical and horizontal mixing layer widths of two identical turbulent air jets impinging at three different angles; as well as the time it takes for the mixture to travel downstream from the jets origin. The current results show an increase in the mixing layer width by approximately 3 diameters near the impingement point in both the vertical and horizontal directions when the transient case is compared to the steady-state cases. Also, by increasing the impingement point from 30 to 60 deg the maximum growth in both the horizontal and vertical directions is increased by approximately 30% (i.e., 1 diameter). Finally, by increasing the impingement angle from 30 to 60 deg the time it takes for the mixture to travel downstream from the jet origin to x/D = 15 increases by more than a factor of two.


Articles with similar content:

OPTICAL ANALYSIS OF THE MIXING EFFECT IN FULLY DEVELOPED LIKE-DOUBLET IMPINGING JET SPRAYS
Atomization and Sprays, Vol.22, 2012, issue 5
Berlin Huang, Tony Yuan
BASIC STUDY ON VAPOR SUPPRESSION
International Heat Transfer Conference 5, Vol.5, 1974, issue
Saburo Toda, Tatsuo Egusa , Akio Kudo
Heat transfer in inclined and direct impinging synthetic jets
ICHMT DIGITAL LIBRARY ONLINE, Vol.0, 2012, issue
Udaysinh S. Bhapkar , Atul Srivastava, B. Puranik , A. Agrawal
FLAMMABILITY CHARACTERISTICS OF THE ROD-STABILIZED LAMINAR PREMIXED FLAME
International Journal of Energy for a Clean Environment, Vol.8, 2007, issue 2
C. W. Leung, C. S. Cheung, M. Drkos
DIRECT SIMULATION OF IMPINGING PLANE FOUNTAINS IN A HOMOGENEOUS FLUID
International Heat Transfer Conference 13, Vol.0, 2006, issue
Steven W. Armfield, Nagarathinam Srinarayana, Wenxian Lin, Geordie D. McBain