年間 6 号発行
ISSN 印刷: 1940-2503
ISSN オンライン: 1940-2554
Indexed in
EVALUATION OF THE VAPORIZATION ENERGY OF A DIESEL AND A BIODIESEL SPRAY VIA INFRARED IMAGING AND 1D MODEL
要約
This paper deepens the study on fuel evaporation in a modern internal combustion engine fed with commercial diesel fuel and the biofuel rapeseed methyl ester (RME) by modeling and infrared diagnostics. A one-dimensional (1D) model has been coupled to experimental results of infrared imaging measurements carried out in a research compression ignition engine equipped with the head of a commercial diesel engine. Images of the in-cylinder processes have been recorded at different crank angles through the optical access in the piston. An infrared band-pass filter has been used to isolate the fuel vapor phase (3.4 µm) and to analyze the spatial evolution and concentration of fuel in the combustion chamber. On the other hand, a 1D model of fuel injection has been implemented to calculate the instantaneous fuel vapor mass and the evaporation rate. The energy required for the vaporization of the fuel and its contribution to the calculated rate of heat release in the cylinder has been evaluated. Model results of fuel concentration inside the jet structure are in line with qualitative infrared data. A slower evaporation rate has been estimated for RME and a correspondence between the peak of evaporation rate and the IR signal has been noted.
-
Abramovich, G.N., Jet of an Incompressible Fluid in a Coflowing External Stream, The Theory of Turbulent Jets, Ch. 5, Schindel, L. (ed.), Cambridge: MIT Press, 1963.
-
Agarwal, A.K., Som, S., Shukla, P.C., Goyal, H., and Longman, D., In-Nozzle Flow and Spray Characteristics for Mineral Diesel, Karanja, and Jatropha Biodiesels, Appl. Energy, vol. 156, pp. 138-148, 2015.
-
Aronsson, U., Chartier, C., Horn, U., Andersson, O., Johansson, B., and Egnell, R., Heat Release Comparison between Optical and All-Metal HSDI Diesel Engines, SAE Tech. Paper 2008-01-1062, 2008.
-
Bosch, Diesel-Engine Management Common Rail, 2nd Ed., Warrendale, PA: SAE International, 1999.
-
Bowditch, F.W., A New Tool for Combustion Research a Quartz Piston Engine, SAE Tech. Paper 610002,1961.
-
Colban, W.F., Kim, D., Miles, P.C., Oh, S., Opat, R., Krieger, R., Foster, D., Durrett, R.P., Manuel, A., and Gonzalez, D., A Detailed Comparison of Emissions and Combustion Performance between Optical and Metal Single-Cylinder Diesel Engines at Low Temperature Combustion Conditions, SAE Int. J. Fuels Lubricants, vol. 1,no. 1,pp. 505-519,2009.
-
Cummins, C.L., Jr., Internal Fire, Lake Oswego, OR: Carnot Press, 1976.
-
Eagle, W.E., Malbec, L.-M., and Musculus, M.P., Comparing Vapor Penetration Measurements from IR Thermography of C-H Stretch with Schlieren during Fuel Injection in a Heavy-Duty Diesel Engine, 9th U.S. Natl. Combustion Meeting Organized by Central States Section of Combustion Inst., Cincinatti, OH, May 17-20, 2015.
-
Emission Standards, EU: Cars and Light Trucks, accessed July 03, 2019, from https://www.dieselnet.com/standards/eu/ld.php, 2016.
-
Grzeschik, P., Laumen, H.-J., and Schlemmer Kelling, U., FEV HiFORS Injector with Continuous Rate Shaping: Influence on Mixture Formation and Combustion Process, Energy Env., pp. 123-135, 2014.
-
Haoye, L., Xiao, M., Bowen, L., Longfei, C., Zhi, W., and Jianxin, W., Combustion and Emission Characteristics of a Direct Injection Diesel Engine Fueled with Biodiesel and PODE/Biodiesel Fuel Blends, Fuel, vol. 209, pp. 62-68, 2017.
-
Heywood, J.B., Internal Combustion Engine Fundamentals, vol. 930, New York: McGraw-Hill, 1988.
-
Hu, Z., Somers, L., Davies, T., McDougall, A., and Cracknell, R., A Study of Liquid Fuel Injection and Combustion in a Constant Volume Vessel at Diesel Engine Conditions, Fuel, vol. 107, pp. 63-73, 2013.
-
Jansons, M., Lin, S., and Rhee, K., Infrared Spectral Analysis of Engine Preflame Emission, Int. J. Engine Res., vol. 9, no. 3, pp. 215-237, 2008.
-
Klingbeil, A.E., Jeffries, J.B., and Hanson, R.K., Temperature-Dependent Mid-IR Absorption Spectra of Gaseous Hydrocarbons, J. Quant. Spectrosc. Radiative Trans., vol. 107, no. 3, pp. 407-420, 2007.
-
Lemaire, R., Bejaoui, S., and Therssen, E., Study of Soot Formation during the Combustion of Diesel, Rapeseed Methyl Ester and Their Surrogates in Turbulent Spray Flames, Fuel, vol. 107, pp. 147-161, 2013.
-
Lide, D.R., CRC Handbook of Chemistry and Physics, Boca Raton, FL: CRC Press, 2004.
-
Mancaruso, E., Sequino, L., and Vaglieco, B., First and Second Generation Biodiesels Spray Characterization in a Diesel Engine, Fuel, vol. 90, pp. 2870-2883, 2011.
-
Mancaruso, E., Marialto, R., Sequino, L., and Vaglieco, B.M., Comparison of Spray Characteristics Measured in an Optical Single Cylinder Diesel Engine with 1D Model, SAE Tech. Paper 2014-01-1424, 2014.
-
Mancaruso, E., Sequino, L., and Vaglieco, B., Analysis of the Pilot Injection Running Common Rail Strategies in a Research Diesel Engine by Means of Infrared Diagnostics and 1D Model, Fuel, vol. 178, pp. 188-201, 2016.
-
Mancaruso, E., Sequino, L., and Vaglieco, B.M., Analysis of Spray Injection in a Light Duty CR Diesel Engine Supported by Non-Conventional Measurements, Fuel, vol. 158, pp. 512-522,2015.
-
Musculus, M.P. andKattke, K., Entrainment Waves in Diesel Jets, SAE Int. J. Engines, vol. 2, no. 1, pp. 1170-1193, 2009.
-
Naber, J.D. and Siebers, D.L., Effects of Gas Density and Vaporization on Penetration and Dispersion of Diesel Sprays, SAE Tech. Paper 960034, 1996.
-
Payri, F., Payri, R., Bardi, M., and Carreres, M., Engine Combustion Network: Influence of the Gas Properties on the Spray Penetration and Spreading Angle, Exp. Therm. Fluid Sci., vol. 53, pp. 236-243, 2014.
-
Pickett, L.M., Manin, J., Genzale, C.L., Siebers, D.L., Musculus, M.P., and Idicheria, C.A., Relationship between Diesel Fuel Spray Vapor Penetration/Dispersion and Local Fuel Mixture Fraction, SAE Int. J. Engines, vol. 4, no. 1, pp. 764-799, 2011.
-
Pickett, L.M., Manin, J., Kastengren, A., and Powell, C., Comparison of Near-Field Structure and Growth of a Diesel Spray Using Light-Based Optical Microscopy and X-Ray Radiography, SAE Int. J. Engines, vol. 7, no. 2, pp. 1044-1053, 2014.
-
Pickett, L.M., Manin, J., Payri, R., Bardi, M., and Gimeno, J., Transient Rate of Injection Effects on Spray Development, SAE Tech. Paper 2013-24-0001, 2013.
-
Rottmann, M., Menne, C., Pischinger, S., Luckhchoura, V, and Peters, N., Injection Rate Shaping Investigations on a Small-Bore DI Diesel Engine, SAE Tech. Paper 2009-01-0850, 2009.
-
Sequino, L., An Innovative Optical Diagnostics for Injection Process in CI Engines-Visible/Infrared Imaging Coupled to 1D Modeling, Saarbriicken, Germany: LAP LAMBERT Academic Publishing Imprint, 2016.
-
Siebers, D.L., Scaling Liquid-Phase Fuel Penetration in Diesel Sprays based on Mixing-Limited Vaporization, SAE Tech. Paper 1999-01-0528, 1999.
-
Stone, R., Introduction to Internal Combustion Engines, Basingstoke, UK: Palgrave Macmillan, 2012.
-
Tomita, E., Kawahara, N., Nishiyama, A., and Shigenaga, M., In Situ Measurement of Hydrocarbon Fuel Concentration near a Spark Plug in an Engine Cylinder Using the 3.392 mm Infrared Laser Absorption Method: Application to an Actual Engine, Meas. Sci. Technol., vol. 14, no. 8, pp. 1357-1363, 2003.
-
Zhou, G., Roby, S., Wei, T., and Yee, N., Fuel Heat of Vaporization Values Measured with Vacuum Thermogravimetric Analysis Method, Energy Fuels, vol. 28, no. 5,pp. 3138-3142, 2014.
-
Ramanan C. J. , Bora Bhaskor J., Alom Nur , Buradi Abdulrajak , Shukla Shivam , INVESTIGATION OF DEAD-END FILTRATION OF CRUDE BIODIESEL USING REVERSE OSMOSIS MEMBRANE THROUGH CFD SIMULATION , International Journal of Energy for a Clean Environment, 23, 6, 2022. Crossref