ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Atomization and Sprays
インパクトファクター: 1.189 5年インパクトファクター: 1.596 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN 印刷: 1044-5110
ISSN オンライン: 1936-2684

巻:
巻 28, 2018 巻 27, 2017 巻 26, 2016 巻 25, 2015 巻 24, 2014 巻 23, 2013 巻 22, 2012 巻 21, 2011 巻 20, 2010 巻 19, 2009 巻 18, 2008 巻 17, 2007 巻 16, 2006 巻 15, 2005 巻 14, 2004 巻 13, 2003 巻 12, 2002 巻 11, 2001 巻 10, 2000 巻 9, 1999 巻 8, 1998 巻 7, 1997 巻 6, 1996 巻 5, 1995 巻 4, 1994 巻 3, 1993 巻 2, 1992 巻 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2013006939
pages 343-361

THREE-DIMENSIONAL INVESTIGATIONS OF FLOW CHARACTERISTICS IN A DIESEL NOZZLE

Weidi Huang
School of Automotive Studies, Tongji University, Shanghai 200092, China
Ya Gao
School of Automotive Studies, Tongji University, Shanghai 200092, China
Zhilong Li
School of Automotive Studies, Tongji University, Shanghai 200092, China
Liguang Li
School of Automotive Studies, Tongji University, Shanghai 200092, China
Zhengbai Liu
Dongfeng Motor Corporation, Wuhan 430056, China
Zhijun Wu
School of Automotive Studies, Tongji University, Shanghai 200092, China

要約

Simulation investigations of flow characteristic in diesel nozzles are basically performed using the simplified and idealized geometry models. Therefore, these simulations are essentially two-dimensional (2D), and unavoidably have deviations from real flow characteristics due to lack of three-dimensional (3D) geometry information. In this study, based on the high energy x-ray CT scan, the inner nozzle structures are measured in detail, and the measurement results are applied to generate the 3D computational meshes. The results of the 2D and the 3D simulations are compared to see the effect of the 3D simulation on the flow characteristics in the nozzles. The investigation results show that because of the rough surface and uneven distributions of geometry parameters in the azimuthal direction of the nozzle orifice revealed by the CT scan, the differences of the flow characteristics between the 2D and the 3D simulations are obvious. They exist at the orifice inlet, the orifice outlet, and along the orifice axis. The improvement of evenness of geometry parameter distributions can reduce the differences between the 2D and the 3D simulations. The 3D computational mesh, which contains more geometry parameter information than the 2D one, can reveal details of the influences of geometry parameters on the internal flow of nozzle, and gain more precise simulation results and insight into the flow characteristics under the real nozzle conditions.