ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Atomization and Sprays
インパクトファクター: 1.262 5年インパクトファクター: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN 印刷: 1044-5110
ISSN オンライン: 1936-2684

巻:
巻 29, 2019 巻 28, 2018 巻 27, 2017 巻 26, 2016 巻 25, 2015 巻 24, 2014 巻 23, 2013 巻 22, 2012 巻 21, 2011 巻 20, 2010 巻 19, 2009 巻 18, 2008 巻 17, 2007 巻 16, 2006 巻 15, 2005 巻 14, 2004 巻 13, 2003 巻 12, 2002 巻 11, 2001 巻 10, 2000 巻 9, 1999 巻 8, 1998 巻 7, 1997 巻 6, 1996 巻 5, 1995 巻 4, 1994 巻 3, 1993 巻 2, 1992 巻 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.2018026194
pages 779-795

MACROSCOPIC AND MICROSCOPIC CHARACTERISTICS OF GASOLINE AND BUTANOL SPRAY ATOMIZATION UNDER ELEVATED AMBIENT PRESSURES

Yanfei Li
State Key Laboratory of Automotive Safety and Energy, Tsinghua University, Beijing, 100084, China
Hengjie Guo
State Key Laboratory of Automotive Safety and Energy, Tsinghua University, Beijing, 100084, China
Yitao Shen
Automotive Engineering Department, Harbin Institute of Technology (Weihai), Weihai, 264209, China
Xiao Ma
State Key Laboratory of Automotive Safety and Energy, Tsinghua University, Beijing, 100084, China
Longfei Chen
School of Energy and Power Engineering, Energy and Environment International Center, Beihang University, 100091, China
Liuyang Feng
School of Energy and Power Engineering, Energy and Environment International Center, Beihang University, 100091, China

要約

N-butanol has been recognized as a promising alternative fuel in gasoline engines and has outstanding advantages over low-carbon alcohols in terms of energy density and miscibility. In this work, the comparative investigation on the spray behaviors of gasoline and n-butanol was carried out using a commercial gasoline direct injection (GDI) injector. The tests were carried out in a high-pressure constant volume vessel with the injection pressures from 6.0 to 15.0 MPa and ambient pressures from 0.1 to 0.5 MPa. High speed imaging and Phase Doppler Particle Analyzer (PDPA) techniques were used to examine the spray penetration and the droplet atomization process. The results showed that gasoline had a longer penetration length than that of n-butanol in most test conditions mainly due to the longer injection delay caused by the relatively small density and viscosity of gasoline. The relatively poor atomization quality of n-butanol (larger Sauter Mean Diameter) might further contribute for its larger droplet mean velocity than gasoline because less energy was consumed for atomization. Both increasing injection pressure and decreasing ambient pressure could enhance spray atomization and increase droplet mean velocity. However, once the injection pressure was beyond a certain value, its effect on droplet mean velocity was neglectible. The global velocity distribution presented an asymmetric feature with the spray axis in the far field possibly due to the jet-to-jet interaction.


Articles with similar content:

EFFECT OF ETHANOL AND AMBIENT PRESSURE ON PORT-FUEL-INJECTION SPRAYS IN AN OPTICALLY ACCESSIBLE INTAKE CHAMBER
Atomization and Sprays, Vol.21, 2011, issue 5
Evatt R. Hawkes, Srinivas Padala, Sanghoon Kook
SPRAY CHARACTERISTICS OF A PINTLE-TYPE INJECTOR IN A LOW-PRESSURE GAS ENVIRONMENT
Atomization and Sprays, Vol.4, 1994, issue 2
Tokihiro Tsukamoto, Jiro Senda, Hajime Fujimoto, Masashi Yamaguchi
Atomization Characteristics of Liquefied n-Butane Spray Injected by High Injection Pressure
International Journal of Fluid Mechanics Research, Vol.24, 1997, issue 1-3
S. Morita, Jiro Senda, Hajime Fujimoto
EFFECT OF INJECTION PARAMETERS ON SPRAY CHARACTERISTICS OF GAS-TO-LIQUID (GTL), BIODIESEL, AND DIESEL FUEL FOR A MULTI-HOLE INJECTOR IN A DIESEL ENGINE
Atomization and Sprays, Vol.25, 2015, issue 12
Chang Sik Lee, Donggon Lee, Hyun Gu Roh, Kibong Choi
SPRAY CHARACTERISTICS OF A FLOW-BLURRING ATOMIZER
Atomization and Sprays, Vol.20, 2010, issue 9
Ajay Agrawal, Benjamin M. Simmons