ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
Atomization and Sprays
インパクトファクター: 1.262 5年インパクトファクター: 1.518 SJR: 0.814 SNIP: 1.18 CiteScore™: 1.6

ISSN 印刷: 1044-5110
ISSN オンライン: 1936-2684

巻:
巻 29, 2019 巻 28, 2018 巻 27, 2017 巻 26, 2016 巻 25, 2015 巻 24, 2014 巻 23, 2013 巻 22, 2012 巻 21, 2011 巻 20, 2010 巻 19, 2009 巻 18, 2008 巻 17, 2007 巻 16, 2006 巻 15, 2005 巻 14, 2004 巻 13, 2003 巻 12, 2002 巻 11, 2001 巻 10, 2000 巻 9, 1999 巻 8, 1998 巻 7, 1997 巻 6, 1996 巻 5, 1995 巻 4, 1994 巻 3, 1993 巻 2, 1992 巻 1, 1991

Atomization and Sprays

DOI: 10.1615/AtomizSpr.v4.i3.60
pages 325-349

BOUNDARY-LAYER STRIPPING EFFECTS ON DROPLET TRANSCRITICAL CONVECTIVE VAPORIZATION

Jean-Pierre Delplanque
UC Davis
William A. Sirignano
Department of Mechanical and Aerospace Engineering, University of California at Irvine, USA

要約

Previous studies have shown that the surface temperature of a liquid oxygen (LOX) droplet vaporizing in a supercritical quiescent environment reaches the computed critical mixture value; therefore, a model for supercritical combustion is needed. The purpose of this work is to investigate convective effects. A spherically symmetric model is constructed with an extension of the film model for the gas phase. The energy equation in the droplet is solved numerically and the high-pressure phase equilibrium is computed from the chemical potential equality for each component in each phase, using the Redlich-Kwong equation of state. Because of the reduced surface tension, the droplet undergoes mass removal from its surface by aerodynamic shearing (boundary-layer stripping). It is shown that, in a rocket engine, a LOX droplet is likely to undergo boundary-layer stripping for most of its lifetime. A simple integral analysis of the coupled gas−liquid boundary layers at the droplet interface yields an expression for the mass removal rate that includes blowing effects and that is shown to be much larger than the vaporization rate. The effect of stripping on the heat transfer into the droplet is evaluated with a modified film model. Results show that, in most cases, stripping precludes criticality at the interface. Computations also show that stripping reduces the predicted droplet lifetime by at least one order of magnitude, thus affecting significantly the range of frequencies in which the gasification process might be driving combustion instabilities. The computed droplet lifetime is compared to the expressions available in the literature. The sensitivity of the predicted droplet behavior to the threshold value of the stripping breakup criterion is demonstrated.


Articles with similar content:

REAL GAS EFFECTS IN MIXING-LIMITED DIESEL SPRAY VAPORIZATION MODELS
Atomization and Sprays, Vol.20, 2010, issue 7
Carlo C. M. Luijten, Chris Kurvers
QUANTIFICATION OF TRANSIENT FUEL FILMS UNDER ELEVATED AMBIENT PRESSURE ENVIRONMENTS
Atomization and Sprays, Vol.22, 2012, issue 1
Phil J. Bowen, Mario Alonso, R. Gilchrist, S. M. Sapsford, Peter J. Kay
CALCULATION OF ESSENTIAL INPUT PARAMETERS FOR ESTIMATING THE EVAPORATION OF MULTICOMPONENT LIQUID DROPLETS
Interfacial Phenomena and Heat Transfer, Vol.1, 2013, issue 3
Andras Dallos, Gabor Jarvas, Christian Quellet
DROPLET STREAM DYNAMICS AT HIGH AMBIENT PRESSURE
Atomization and Sprays, Vol.6, 1996, issue 4
C. S. Connon, Derek Dunn-Rankin
SIMULATION OF LIQUID SPRAY ATOMIZATION IN SUPERCRITICAL ENVIRONMAEN USING VARIOUS SURFACE TENSION MODELS
ICLASS 94
Proceedings of the Sixth International Conference on Liquid Atomization and Spray Systems, Vol.0, 1994, issue
S.J. Neches, Anil K. Kulkarni