ライブラリ登録: Guest
Begell Digital Portal Begellデジタルライブラリー 電子書籍 ジャーナル 参考文献と会報 リサーチ集
International Journal of Fluid Mechanics Research
ESCI SJR: 0.206 SNIP: 0.446 CiteScore™: 0.5

ISSN 印刷: 2152-5102
ISSN オンライン: 2152-5110

巻:
巻 46, 2019 巻 45, 2018 巻 44, 2017 巻 43, 2016 巻 42, 2015 巻 41, 2014 巻 40, 2013 巻 39, 2012 巻 38, 2011 巻 37, 2010 巻 36, 2009 巻 35, 2008 巻 34, 2007 巻 33, 2006 巻 32, 2005 巻 31, 2004 巻 30, 2003 巻 29, 2002 巻 28, 2001 巻 27, 2000 巻 26, 1999 巻 25, 1998 巻 24, 1997 巻 23, 1996 巻 22, 1995

International Journal of Fluid Mechanics Research

DOI: 10.1615/InterJFluidMechRes.v36.i5.30
pages 424-446

Impulsively Started Flow of a Micropolar Fluid Past a Circular Cylinder

F. M. Mahfouz
Mechanical Engineering Department, UET, Taxila, Pakistan [on leave from Menoufia University, Egypt]

要約

The characteristics of the unsteady laminar impulsive flow of micropolar fluid over a horizontal circular cylinder is investigated. The conservation equations for mass, linear momentum and angular momentum are solved in order to determine the flow structure and associated hydrodynamic forces and couple. The main controlling parameters are Reynolds number and material parameters of micropolar fluid. The dimensionless material parameters are the vortex viscosity, the spin gradient viscosity and the micro-inertia density. These parameters are selected in the range from 0 to 10 while the Reynolds number is considered up to 180. The results have shown that the micro-inertia density has no effect on micropolar fluid flow characteristics while the effect of both vortex viscosity and spin gradient viscosity is noticeable. The study has shown that both the Strouhal number and the amplitude of oscillating lift force decrease with the increase of vortex viscosity and with the increase, but with a little degree, of spin gradient viscosity. The results have revealed that the drag coefficient does not exhibit a clear general trend as the material parameters vary. The damping effect of micropolar fluid on vortex shedding process should draw the attention to artificially made micropolar fluids as a possible control method for flow separation.


Articles with similar content:

A COMPUTATIONAL STUDY OF HEAT AND MASS TRANSFER FROM A CIRCULAR CYLINDER IN OSCILLATORY FLOW
Heat Transfer Research, Vol.48, 2017, issue 17
Burhan Cuhadaroglu, Şahin Yiğit
PROGNOSIS AND NUMERICAL ANALYSIS OF THE PRESSURE DROP IN SLUSH HYDROGEN VACUUM-JACKETED TRANSFER LINES
Interfacial Phenomena and Heat Transfer, Vol.4, 2016, issue 2-3
T. Hatem, B. Zeghondy, Jad Jelwan, N. Zakhia
On the Unsteady Wake for Flow Past Transversally Vibrating Square Cylinder
International Journal of Fluid Mechanics Research, Vol.37, 2010, issue 4
Pratish P. Patil, Shaligram Tiwari
g-Jitter Free Convection Boundary Layer Flow of a Micropolar Fluid Near a Three-Dimensional Stagnation Point of Attachment
International Journal of Fluid Mechanics Research, Vol.32, 2005, issue 3
Ioan Pop, Norsarahaida Saidina Amin, Sharidan Shafie
LAMINAR PULSATING CONFINED JET FLOW OF NANOFLUIDS IN A DUCT WITH ISOFLUX WALL
Heat Transfer Research, Vol.48, 2017, issue 11
A. Arya, M. Rahgoshay, Ali Akbar Ranjbar, Abas Ramiar, M. Rahimi