RT Journal Article ID 58ccba57340df72e A1 Muzzio, Adriano A1 Niro, Alfonso A1 Arosio, S. T1 A REVIEW ON HEAT TRANSFER AND PRESSURE DROP DURING EVAPORATION AND CONDENSATION OF R22 INSIDE 9.52-MM O.D. MICROFIN TUBES OF DIFFERENT GEOMETRIES JF Journal of Enhanced Heat Transfer JO JEH(T) YR 2017 FD 2018-04-23 VO 24 IS 1-6 SP 609 OP 626 K1 Heat transfer K1 enhanced flow boiling K1 convective condensation K1 microfin tubes AB Saturated flow boiling and convective condensation experiments for oil-free Refriger-ant-22 have been carried out with a microfin tube with a new cross-section profile, as well as with two traditional microfin tubes and with a smooth one. All tubes have the same outer diameter. Data are for mass fluxes ranging from about 90 to 400 kg/m2·s. In boiling tests, the nominal saturation temperature is 5°C, with inlet quality varying from 0.2 to 0.6 and the quality variation along the test section ranging from 0.1 to 0.5. In condensation, results are for saturation temperature equal to 35°C, with inlet and outlet qualities of 0.8 and 0.2, respectively. The new microfin tube shows the best thermal performances among the microfin tubes tested, especially in evaporation. For this case, the enhancement factor comes up to 4. Experimental results for microfin tubes are compared with predictions of a correlation scheme recently proposed; these predictions correlate well only with data for the microfin tube with a geometry much similar to one accounted by the scheme. PB Begell House LK https://www.dl.begellhouse.com/journals/4c8f5faa331b09ea,7c902f7e71298fc5,58ccba57340df72e.html