Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
International Journal of Energetic Materials and Chemical Propulsion
ESCI SJR: 0.149 SNIP: 0.16 CiteScore™: 0.29

ISSN Imprimir: 2150-766X
ISSN On-line: 2150-7678

International Journal of Energetic Materials and Chemical Propulsion

DOI: 10.1615/IntJEnergeticMaterialsChemProp.v5.i1-6.550
pages 513-522

BURNING RATE AND PRESSURE DEFLAGRATION LIMIT (PDL) CHARACTERISTICS OF A GAP/AP PROPELLANT SYSTEM

Keiichi Hori
Institute of Space and Astronautical Science (ISAS), Japan Aerospace Exploration Agency (JAXA), 3-1-1 Yoshinodai, Chuo-Ku, Sagamihara, Kanagawa 252-5210, Japan
Masahiro Kohno
Institute of Space and Astronautical Science, 3-1-1 Yoshinodai Sagamihara, Kanagawa 229, Japan
Angelo Volpi
CNPM- National Research Council, Viale F. Baracca, 69 20068 Peschiera Borromeo, Milano, Italy
Claudio Zanotti
TEMPE - National Research Council Via Cozzi 53, 20125 Milano, Italy
Kazushige Kato
Research & Development Department, Taketoyo-Plant, NOF Corporation, 61-1 Kitakomatsudani Taketoyo-cho, Chita-gun, Aichi-ken 470-2398 Japan
Shigefumi Miyazaki
Research & Development Center, IHI Aerospace Co., Ltd. 21-1 Matobashinmachi, Kawagoe-city, Saitama, 350-1107, Japan

RESUMO

For the application to a mass flux controllable gas generator, GAP is one of the most suitable high energetic materials because of its relatively high pressure exponent. However, its PDL and low pressure burning rate characteristics are not fully investigated yet and it is necessary to know them in detail for such an application. Moreover, a GAP/AP propellant system is considered more feasible because the addition of AP to GAP may be effective to extend the combustible region. Therefore, peculiar attention should be paid to burning rate characteristics of a GAP/AP propellant system.
High pressure burning rate of a GAP/AP propellant system has been obtained with a strand burner, and PDL and low pressure burning rates have been investigated by means of a X-ray device as functions of AP content, AP particle size and depressurization rate. The X-ray device is, basically, composed of X-ray source, combustion chamber and X-ray sensor, and the depressurization rate is controllable. The signal at the output of the sensor is sent to a digital acquisition system controlled by PC. Precise calibration between sample length and X-ray signal gives instantaneous sample length during the burning test, thus, instantaneous burning rate taking its time derivative. Therefore, it is possible to obtain low pressure burning rate and PDL simultaneously in one test at a certain depressurization rate. Results of PDL and low pressure burning rate measurements of a GAP/AP propellant system are hereafter presented and discussed.

Palavras-chave: GAP, GAP/ÀÐ, PDL, X-ray, Burning Rate

Articles with similar content:

TRANSIENT BURNING BEHAVIOR OF PHASE-STABILIZED AMMONIUM NITRATE BASED AIRBAG PROPELLANT
International Journal of Energetic Materials and Chemical Propulsion, Vol.11, 2012, issue 5
Eric Boyer, Jonathan T. Essel, Baoqi Zhang, Kenneth K. Kuo
APPROPRIATENESS OF BURNING RATE MEASURING TECHNIQUE WITH THE MEASURING CONDITIONS AND REQUESTED DATA
International Journal of Energetic Materials and Chemical Propulsion, Vol.17, 2018, issue 4
Ondrej Vodochodsky, Ahmed Maraden, Robert Matyas, Petr Stojan
ACOUSTIC EMISSION OF UNDERWATER BURNING SOLID ROCKET PROPELLANTS
International Journal of Energetic Materials and Chemical Propulsion, Vol.5, 2002, issue 1-6
D. Ruspa, S. Rampichini
RADIATIVE IGNITION OF SOLID PROPELLANTS: A PRACTICAL APPROACH
International Journal of Energetic Materials and Chemical Propulsion, Vol.9, 2010, issue 4
Franck Cauty, Yves Fabignon, Charles Erades
Development of an in-Plane Thermal Diffusivity Measurement Method with a Lock-in Thermography and Application to High Thermal Conductive Cfrps
International Heat Transfer Conference 15, Vol.30, 2014, issue
Hosei Nagano, Takuya Ishizaki