Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Heat Transfer Research
Fator do impacto: 0.404 FI de cinco anos: 0.8 SJR: 0.264 SNIP: 0.504 CiteScore™: 0.88

ISSN Imprimir: 1064-2285
ISSN On-line: 2162-6561

Volumes:
Volume 50, 2019 Volume 49, 2018 Volume 48, 2017 Volume 47, 2016 Volume 46, 2015 Volume 45, 2014 Volume 44, 2013 Volume 43, 2012 Volume 42, 2011 Volume 41, 2010 Volume 40, 2009 Volume 39, 2008 Volume 38, 2007 Volume 37, 2006 Volume 36, 2005 Volume 35, 2004 Volume 34, 2003 Volume 33, 2002 Volume 32, 2001 Volume 31, 2000 Volume 30, 1999 Volume 29, 1998 Volume 28, 1997

Heat Transfer Research

DOI: 10.1615/HeatTransRes.v35.i12.50
10 pages

Experimental and Computational Investigation of the Hydrodynamics and Heat Transfer in a Flat Channel of Variable Width for Smooth and Intensified Surfaces

R. Banker
General Electric CR&D, USA
Mikhail Ya. Belenkiy
JSC "I. I. Polzunov Central Boiler and Turbine Institute" (NPO TsKTI), St. Petersburg, 195257, Russia
Mikhail Gotovskii
I. I. Polzunov Scientific and Development Association on Research and Design of Power Equipment (NPO TsKTI), 3/6 Atamanskaya Str., St. Petersburg, 191167, Russia
B. S. Fokin
JSC "I. I. Polzunov Central Boiler and Turbine Institute" (NPO TsKTI), St. Petersburg, 195257, Russia

RESUMO

We present the results of experimental and computational investigation of the resistance and heat transfer in a flat channel of variable width with converging and diverging flows at rather small convergence (divergence) angles. The results were obtained for both smooth surfaces and surfaces with intensification by dimples. It is showed experimentally that for long channels, laminarization and flow instability effects appear even at angles of 1-2°. But there is a noticeable influence only on the resistance coefficient, whereas the behavior of heat transfer is almost the same as in the absence of acceleration for both smooth and intensified surface. The numerical analysis of convective heat transfer in a narrow converging channel with a package of 15 conical dimples on one of its sides generally confirmed the data obtained in physical experiments on the advanced increase in heat transfer as compared to hydraulic resistance. Vortex-type flow synchronization effect in dimples is established.


Articles with similar content:

Estimation of the Thermohydraulic Efficiency of Heat Exchanging Apparatuses with Twisted Tubes
Heat Transfer Research, Vol.37, 2006, issue 4
Boris V. Dzyubenko
HEAT TRANSFER IN THE TRANSITIONAL FLOW REGIME OVER SURFACE ROUGHNESS
International Heat Transfer Conference 9, Vol.3, 1990, issue
Anupras Slanciauskas, Antanas Pedisius
HEAT TRANSFER CHARACTERISTICS OF THE PIN-FIN HEAT SINK (MECHANISM AND EFFECT OF TURBULENCE IN THE PIN ARRAY)
Transport Phenomena in Thermal Engineering. Volume 2, Vol.0, 1993, issue
Akira Murata, Ko Minakami, Sadanari Mochizuki, Hideo Iwasaki, Yoshinao Yagi
POOL BOILING ON POROUS SURFACES WITH MICRO-GROOVES
International Heat Transfer Conference 10, Vol.12, 1994, issue
Tongze Ma, Zhiping Lin, Zhengfang Zhang
SIMULATION OF TORNADO - LIKE HEAT TRANSFER AT THE FLOW PASSING A RELIEFWITH DIMPLES
International Heat Transfer Conference 12, Vol.23, 2002, issue
V. L. Zhdanov, Sergey A. Isaev, Alexander Leontiev