Inscrição na biblioteca: Guest
Portal Digital Begell Biblioteca digital da Begell eBooks Diários Referências e Anais Coleções de pesquisa
Journal of Enhanced Heat Transfer
Fator do impacto: 0.562 FI de cinco anos: 0.605 SJR: 0.175 SNIP: 0.361 CiteScore™: 0.33

ISSN Imprimir: 1065-5131
ISSN On-line: 1026-5511

Volumes:
Volume 26, 2019 Volume 25, 2018 Volume 24, 2017 Volume 23, 2016 Volume 22, 2015 Volume 21, 2014 Volume 20, 2013 Volume 19, 2012 Volume 18, 2011 Volume 17, 2010 Volume 16, 2009 Volume 15, 2008 Volume 14, 2007 Volume 13, 2006 Volume 12, 2005 Volume 11, 2004 Volume 10, 2003 Volume 9, 2002 Volume 8, 2001 Volume 7, 2000 Volume 6, 1999 Volume 5, 1998 Volume 4, 1997 Volume 3, 1996 Volume 2, 1995 Volume 1, 1994

Journal of Enhanced Heat Transfer

DOI: 10.1615/JEnhHeatTransf.v17.i1.30
pages 45-57

Forced Convective Flow Drag and Heat Transfer Characteristics of CuO Nanoparticle Suspensions and Nanofluids in a Small Tube

Liang Liao
School of Mechanical Engineering, Shanghai Jiaotong University
Zhenhua Liu
Shanghai Jiao Tong University, 800 Dong Chuan Rd. Minhang District, Shanghai 200240, China
Ran Bao
School of Mechanical Engineering, Shanghai Jiaotong University

RESUMO

The present experiment investigates the forced convective flow drag and enhanced heat transfer of water−CuO nanoparticle suspensions and nanofluids in a steel tube with an inner diameter of 1.02 mm. The nanoparticle suspension consists of a base fluid and nanoparticles, while the nanofluid consists of a base fluid, nanoparticles, and a surfactant. Previous studies were all concerned with nanofluids without any research attention paid to nanoparticle suspensions yet. The effect of fluid temperature on heat transfer and flow drag has never been considered as well. This study aims to understand how surfactant and fluid temperature affect forced convective flow drag and heat transfer. The experimental results show that: fluid temperature has a great effect on the heat transfer of both nanoparticle suspensions and nanofluids; for both of them, the heat transfer coefficient enhancement comes mainly from the increasing effective thermal conductivity. The surfactant has no influence on the heat transfer. However, it does affect the flow drag characteristic. For suspensions, flow drag is greater than that of water in the laminar flow region, while it is obviously lower than that of water in the turbulent flow region. For nanofluids, the flow drag is greater than that of water in the whole flow region. Fluid temperature has no obvious effect on flow drag of both suspensions and nanofluid.


Articles with similar content:

NUMERICAL INVESTIGATION OF TRIPLE CONCENTRIC−TUBE HEAT EXCHANGER USING Al2O3-WATER NANOFLUIDS
Proceedings of the 24th National and 2nd International ISHMT-ASTFE Heat and Mass Transfer Conference (IHMTC-2017), Vol.0, 2017, issue
Manish Mishra, Tarikayehu Amanuel
Thermal Fluid Flow Transport Characteristics in Pipe Flow Using Graphene-Oxide-Nanofluid
International Heat Transfer Conference 15, Vol.23, 2014, issue
Hajime Yoshino, Shuichi Torii
THERMOSYPHON PERFORMANCE IN DEPENDENCE OF CARBON-BASED NANOFLUIDS
3rd Thermal and Fluids Engineering Conference (TFEC), Vol.28, 2018, issue
M. Woluntarski , Matthias H. Buschmann, B. Zajaczkowski , Agnieszka Wlazlak
NANOFLUID HEAT TRANSFER COEFFICIENT ENHANCEMENT IN MICROCHANNELS
3rd Thermal and Fluids Engineering Conference (TFEC), Vol.28, 2018, issue
Sarah Simpson, Saeid Vafaei
Boiling Heat Transfer Characteristics in Small Vertical Tubes Submerged in Saturated nanoparticle Suspensions
Journal of Enhanced Heat Transfer, Vol.15, 2008, issue 2
Zhenhua Liu, Lun-Chun Lv